89170
1.INSTALL AIRBAG SENSOR ASSEMBLY
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
| *a | Fulcrum Length |
Using SST, install the airbag sensor assembly with the 3 bolts.
Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
This torque value is effective when SST is parallel to a torque wrench.
If the airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
When installing the airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
When the ignition switch is first turned to ON after the airbag sensor assembly has been replaced, make sure that no one is in the vehicle.
| *1 | Waterproof Sheet |
Connect the connectors to the airbag sensor assembly as shown in the illustration.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Check that the waterproof sheet is properly set.
Check that there is no looseness in the installation parts of the airbag sensor assembly.
58861B
2.INSTALL NO. 1 CONSOLE BOX DUCT
58544A
3.INSTALL FLOOR CARPET BRACKET LH
58543B
4.INSTALL FLOOR CARPET BRACKET RH
58817A
5.INSTALL FRONT NO. 2 CONSOLE BOX INSERT
58816B
6.INSTALL CONSOLE BOX INSERT
74110E
7.INSTALL FRONT ASH RECEPTACLE ASSEMBLY
58831A
8.INSTALL FRONT CONSOLE UPPER PANEL GARNISH
55432D
9.INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
53601
10.CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
55318C
11.INSTALL INSTRUMENT SIDE PANEL LH
62312B
12.CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
62112A
13.INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
67914
14.INSTALL FRONT DOOR SCUFF PLATE LH
55303B
15.INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
55607
16.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55317A
17.INSTALL INSTRUMENT SIDE PANEL RH
62311B
18.CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
62111A
19.INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION).
67913
20.INSTALL FRONT DOOR SCUFF PLATE RH
Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION).
21.INSTALL CONSOLE BOX ASSEMBLY
22.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
23. PERFORM DIAGNOSTIC SYSTEM CHECK
24.INSPECT SRS WARNING LIGHT