1.REMOVE FRONT SEAT ASSEMBLY RH
67913
2.REMOVE FRONT DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
62311B
3.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY>REMOVAL
67917A
4.REMOVE REAR DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
62331A
5.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY>REMOVAL
73233
6.REMOVE LAP BELT OUTER ANCHOR COVER
Use the same procedure as for the LH side.
Click hereVehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY>REMOVAL
73210
7.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY>REMOVAL
62413A
8.REMOVE CENTER PILLAR LOWER GARNISH RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
9.REMOVE REAR SEAT CUSHION ASSEMBLY
72693
10.REMOVE REAR SEAT CUSHION LOCK HOOK
11.REMOVE REAR SIDE SEATBACK ASSEMBLY RH
64719A
12.REMOVE LUGGAGE COMPARTMENT DOOR COVER
64711
13.REMOVE LUGGAGE COMPARTMENT FLOOR MAT
58387
14.REMOVE REAR FLOOR FINISH PLATE
64725D
15.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
| *1 | Pin |
Push the pin and remove the No. 1 luggage compartment trim hook.
64721
16.REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER RH
77306
17.REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY
Remove the screw.
Disengage the guide and disconnect the fuel lid lock open lever sub-assembly as shown in the illustration.
Disconnect the fuel lid lock control cable sub-assembly and luggage door lock control cable sub-assembly and remove the fuel lid lock open lever sub-assembly.
64607
18.REMOVE LUGGAGE DOOR LOCK CONTROL CABLE SUB-ASSEMBLY
Disengage the 2 clamps.
Disengage the clamp and disconnect the wire harness.
Disengage the 2 clamps and remove the 2 scuff plate clips.
Turn back the floor carpet so that the luggage door lock control cable sub-assembly can be removed.
| *1 | Tape |
| *2 | Fuel Lid Lock Control Cable Sub-assembly |
| *3 | Luggage Door Lock Control Cable Sub-assembly |
Remove the 2 pieces of tape that connect the fuel lid lock control cable sub-assembly and luggage door lock control cable sub-assembly.
Disengage the guide as shown in the illustration.
Disconnect the luggage door lock control cable sub-assembly.
Disengage the 2 clamps and disconnect the luggage door lock control cable sub-assembly.
Disengage the 10 clamps and remove the luggage door lock control cable sub-assembly.
| *1 | Luggage Door Lock Control Cable Sub-assembly | *2 | Fuel Lid Lock Control Cable Sub-assembly |