1.REMOVE FRONT SEAT ASSEMBLY LH
67914
2.REMOVE FRONT DOOR SCUFF PLATE LH
62312B
3.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
67918A
4.REMOVE REAR DOOR SCUFF PLATE LH
62332A
5.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
73233
6.REMOVE LAP BELT OUTER ANCHOR COVER
73220
7.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH
62414A
8.REMOVE CENTER PILLAR LOWER GARNISH LH
9.REMOVE REAR SEAT CUSHION ASSEMBLY
72693
10.REMOVE REAR SEAT CUSHION LOCK HOOK
11.REMOVE REAR SIDE SEATBACK ASSEMBLY LH
64719A
12.REMOVE LUGGAGE COMPARTMENT DOOR COVER
64711
13.REMOVE LUGGAGE COMPARTMENT FLOOR MAT
58387
14.REMOVE REAR FLOOR FINISH PLATE
64725D
15.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
64722
16.REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER LH
77306
17.REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY
77035
18.REMOVE FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY
Disengage the 2 clamps.
Disengage the clamp and disconnect the wire harness.
Disengage the 2 clamps and remove the 2 scuff plate clips.
Turn back the floor carpet so that the luggage door lock control cable sub-assembly and fuel lid lock control cable sub-assembly can be removed.
Disengage the guide as shown in the illustration.
Disconnect the luggage door lock control cable sub-assembly.
Disengage the clamp and disconnect the luggage door lock control cable sub-assembly.
| *1 | Cutout |
| *2 | Guide <A> |
Rotate the fuel filler opening lid lock retainer as shown in the illustration to align the cutouts with the guides <A>, and then pull the fuel filler opening lid lock retainer.
| *1 | Cutout |
| *2 | Guide <B> |
Rotate the fuel filler opening lid lock retainer as shown in the illustration to align the cutouts with guides <B>, and then pull the fuel filler opening lid lock retainer.
| *1 | Cutout |
| *2 | Guide <C> |
| *3 | Guide <B> |
Pull out the fuel filler opening lid lock retainer with both guides <B> and <C> aligned with the cutouts.
Disengage the 2 claws and remove the fuel filler opening lid lock retainer.
Disengage the 10 clamps and remove the fuel lid lock control cable sub-assembly and luggage door lock control cable sub-assembly.
| *1 | Fuel Lid Lock Control Cable Sub-assembly | *2 | Luggage Door Lock Control Cable Sub-assembly |
Using a knife, cut off the clamp as shown in the illustration.
| *1 | Tape | - | - |
| *a | Cut | - | - |
Be careful not to damage the vehicle fuel lid lock control cable sub-assembly and luggage door lock control cable sub-assembly.
Remove the clamp.
Remove the 3 pieces of tape and fuel lid lock control cable sub-assembly.