| B2271
|
Ignition Hold Monitor Malfunction
|
DTC Output Confirmation Operation
Turn the engine switch on (IG).
- HINT:
-
To turn the engine switch on (IG), carry the electrical key transmitter sub-assembly and press the engine switch twice with the shift lever in P and the brake pedal released.
|
|
| B2274
|
ACC Monitor Malfunction
|
DTC Output Confirmation Operation
Wait 10 seconds after turning the engine switch on (ACC) or on (IG), and then wait another 10 seconds after turning the engine switch off..
|
|
| B2277
|
Detecting Vehicle Submersion
|
DTC Output Confirmation Operation
Wait 300 seconds after connecting the cable to the negative (-) battery terminal.
|
|
| B2282
|
Vehicle Speed Signal Malfunction
|
DTC Output Confirmation Operation
Drive the vehicle for 20 seconds at a vehicle speed of 25 km/h (16 mph) or more, and then drive the vehicle at a vehicle speed of less than 5 km/h (3 mph) for 20 seconds.
|
|
| B2283
|
Vehicle Speed Sensor Malfunction
|
DTC Output Confirmation Operation
Run the engine at an engine speed of 2000 rpm or more for 330 seconds.
|
|
| B2284
|
Brake Signal Malfunction
|
DTC Output Confirmation Operation
Connect the cable to the negative (-) battery terminal, release the brake pedal and wait 20 seconds or more. Then depress the brake pedal for 20 seconds or more.
|
|
| B2285
|
Steering Lock Position Signal Circuit Malfunction
|
DTC Output Confirmation Operation
Disconnect the cable from the negative (-) battery terminal, wait 30 seconds and then reconnect the cable to the negative (-) battery terminal. Wait 40 seconds or more with the engine switch off (with the steering wheel locked), then turn the engine switch on (ACC) (with the steering unlocked) and wait 40 seconds or more.
|
|
| B2286
|
Runnable Signal Malfunction
|
DTC Output Confirmation Operation
Disconnect the cable from the negative (-) battery terminal, wait 30 seconds and reconnect the cable to the negative (-) battery terminal. Wait 20 seconds or more with the engine switch off, then start the engine and maintain an engine speed of 1000 rpm or more for 20 seconds or more.
|
|
| P0335
|
Crankshaft Position Sensor Circuit Malfunction (NE Signal)
|
DTC Output Confirmation Operation
Allow the engine to idle for 10 seconds or more.
|
|
| U0100
|
Lost Communication with ECM / PCM
|
DTC Output Confirmation Operation
Turn the engine switch on (IG) and wait 10 seconds or more.
|
|
| U0140
|
Lost Communication with Main Body ECU
|
DTC Output Confirmation Operation
|
|
| U0155
|
Lost Communication with Combination Meter
|
DTC Output Confirmation Operation
Turn the engine switch on (IG) and wait 10 seconds or more.
|
|