Home › Brake › PARKING BRAKE › PARKING BRAKE ASSEMBLY › from 2015.04
RM2030EQ _54 Brake _014654 PARKING BRAKE _0074526 PARKING BRAKE ASSEMBLY A

PARKING BRAKE  PARKING BRAKE ASSEMBLY  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and the LH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 2.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

Hide 42491 3.REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG

Hide 42431 4.REMOVE REAR DISC

Hide 5.REMOVE PARKING BRAKE SHOE ASSEMBLY

a.
C240915

Remove the parking brake shoe assembly as shown in the illustration.


Hide 46430 6.DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

Hide 7.REMOVE NUT AND SCREW ADJUSTING ASSEMBLY

a.
C240917

Remove the nut and screw adjusting assembly, parking brake tappet and parking brake push rod.


Hide 8.REMOVE ADJUSTMENT PAWL

a.
C240918

Remove the adjustment pawl.


Hide 9.REMOVE PARKING BRAKE SHOE HOLD PLATE

a.
C240919

Remove the parking brake shoe hold bolt and the parking brake shoe hold plate.


Hide 89516D 10.DISCONNECT SKID CONTROL SENSOR WIRE

Hide 42450B 11.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY

Hide 12.SEPARATE DUST PLATE

a.

Separate the dust plate from the parking brake plate sub-assembly.


Hide 13.REMOVE PARKING BRAKE PLATE SUB-ASSEMBLY

a.

Remove the parking brake plate sub-assembly.


Hide 14.REMOVE DUST COVER

a.
C240920N01
2.948,0.219 3.281,0.427 0.333,0.208 10 false (A)

Put a 4 mm (0.157 in.) drill bit into a drill.


b.

Tape the 4 mm (0.157 in.) drill bit with the portion of 5 mm (0.197 in.) from the tip uncovered.

Dimension (A):

5 mm (0.197 in.)


HINT:

Tape the 4 mm (0.157 in.) drill bit to prevent the drill bit from going too deep.



c.

Lightly press the drill against the rivets, drill off the flanges of the rivets, and remove the 2 rivets.

NOTICE:
·

Cover the dust cover with a piece of cloth to prevent rivet fragments and shavings from scattering.

·

Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.

·

Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.

·

Be careful as the cut rivet will be very hot.




d.

Remove the boot retainer and the dust cover.


e.

Even if the flange is taken off, continue to drill the rivet and push out the remaining fragment using a drill.


f.

Using a vacuum cleaner, remove the rivet fragments and shavings.


Hide 15.REMOVE PARKING BRAKE SHOE LEVER

a.

Remove the parking brake shoe lever.