When removing only the ECM, it is not necessary to remove the cool air intake duct seal and battery.
1. PRECAUTION
Perform the Vehicle Identification Number (VIN) registration when replacing the ECM.
Click hereEngine / Hybrid System>2GR-FE ENGINE CONTROL>SFI SYSTEM>REGISTRATION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable from the negative (-) battery terminal, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
53295E
3.REMOVE COOL AIR INTAKE DUCT SEAL
28800
4.REMOVE BATTERY
89661
5.REMOVE ECM
Disconnect the 2 ECM connectors.
Push in the locks on the 2 levers, raise the levers, and disconnect the 2 ECM connectors.
After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting part of the connectors.
Remove the nut.
Remove the screw (A).
Loosen the screw (B) and remove the ECM.
Remove the screw (B).
Remove the 2 screws and No. 2 ECM bracket.
89667E
6.REMOVE NO. 1 ECM BRACKET
Remove the nut.
Disconnect the wire harness clamp.
Disconnect the wire harness clamp.
Remove the nut and No. 1 ECM bracket.