Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › BATTERY SMART UNIT
RM2040EQ _51 Engine / Hybrid System _014692 HYBRID / BATTERY CONTROL _0074889 BATTERY SMART UNIT A

HYBRID / BATTERY CONTROL  BATTERY SMART UNIT  REMOVAL  


PROCEDURE

Hide 3.SEPARATE REAR SEATBACK ASSEMBLY

a.

Fold down the rear seatback assembly RH.


b.
B284995

Using a moulding remover, disengage the claw and guide, and remove the No. 2 room partition cover.


c.

Disconnect the rear seat outer belt from the rear seat center shoulder belt guide.


d.
B284997

Pull the cable in the direction shown in the illustration to release the rear seatback lock and then fold the rear seatback assembly LH forward.


Hide G92Q2 7.REMOVE NO. 2 HYBRID VEHICLE BATTERY SHIELD PANEL

CAUTION:

Wear insulated gloves.


a.
A258777C03
3.063,0.813 2.906,0.813 false 2.698,1.125 3.021,1.125 false 2.76,1.583 2.969,1.583 false 2.26,1.396 2.417,1.396 2.417,1.396 2.625,1.583 false 3.115,0.74 3.417,0.927 0.302,0.188 10 false *1 3,1.521 3.302,1.708 0.302,0.188 10 false *2 2.208,0.854 2.51,1.042 0.302,0.188 10 false *a 3.063,1.052 3.292,1.25 0.229,0.198 10 false *b 2.094,1.313 2.396,1.5 0.302,0.188 10 false *3
*1 Service Plug Grip
*2 Battery Cover Lock Striker
*3 Button
*a Turn
*b Projection


Using the service plug grip, remove the battery cover lock striker.

HINT:

Insert the projection part of the service plug grip, and turn the button of the battery cover lock striker counterclockwise, and release the lock.



b.
A258779

Disconnect the 2 connectors.


c.

Remove the 2 bolts, nut and No. 2 hybrid vehicle battery shield panel.


d.
A260008

Disconnect the 3 wire harness clamps.


Hide 89892A 8.REMOVE BATTERY SMART UNIT

CAUTION:

Wear insulated gloves.


a.
A258780

Disconnect the connector.

NOTICE:

Insulate the removed connector with insulating tape.



b.
A259414C01
2.323,1.073 2.719,1.479 true 2.792,1.448 3.052,1.677 0.26,0.229 10 false *a
*a Black Label


Remove the bolt and battery smart unit.