Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › FRAME WIRE
RM2040EQ _51 Engine / Hybrid System _014692 HYBRID / BATTERY CONTROL _0074893 FRAME WIRE A

HYBRID / BATTERY CONTROL  FRAME WIRE  INSTALLATION  


PROCEDURE

Hide 82164C 1.INSTALL NO. 4 FLOOR WIRE

CAUTION:

Wear insulated gloves.


a.

Install the No. 4 floor wire with 3 new clamps shown in the illustration.

A268763


b.

Install the 5 nuts shown in the illustration.

A268750

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


c.
A268748

Install the wiring harness clamp bracket with the nut and new clamp shown in the illustration.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


d.
A268749

Install the 2 bolts shown in the illustration.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


e.
A259990

Connect the wire harness clamp and install the bolt shown in the illustration.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


f.
A259986

Install the 2 nuts shown in the illustration.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


g.

Connect the connector and 2 wire harness clamps.


h.
A259985

Connect the 2 wire harness clamps shown in the illustration.


i.

Insert the No. 4 floor wire into the floor panel hole.


j.
A259991

Connect the connector and wire harness clamp.


k.
A255166C01
2.229,2.75 1.99,2.854 true 1.104,1.292 1.438,1.292 true 1.115,1.792 1.448,1.792 true 1.792,2.771 2,2.969 0.208,0.198 10 true *1 1.458,1.219 1.667,1.417 0.208,0.198 10 true *a 1.469,1.719 1.677,1.917 0.208,0.198 10 true *b
*1 Shielded Wire Ground
*a Claw
*b Hole


Connect the 2 connectors.


l.

Connect the shielded wire ground.

NOTICE:
·

Make sure that the ends of the No. 4 floor wire do not cross over each other.

·

The connector should be connected securely.

·

Be sure to align the claw of the shielded wire ground with the hole.

·

Be sure to install the shielded wire ground in the correct direction.




Hide G92Q6 2.INSTALL NO. 4 HYBRID BATTERY SHIELD PANEL

Hide 64272B 3.INSTALL ROOM PARTITION BOARD LH

Hide 4.INSTALL REAR SIDE SEATBACK ASSEMBLY RH

Hide 5.INSTALL REAR SEATBACK ASSEMBLY RH

a.

Fold down the rear seatback assembly RH.


Hide 77100 6.INSTALL FUEL TANK ASSEMBLY

Hide 7.INSTALL ENGINE ASSEMBLY WITH TRANSAXLE