43420
1.INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
Coat the spline of the front drive inboard joint assembly with ATF WS.
Coat the lip of the hybrid vehicle transaxle assembly type T oil seal with MP grease.
Align the inboard joint splines, and using a brass bar and a hammer, install the front drive shaft assembly LH.
Face the end gap of the front drive shaft hole snap ring LH downward.
Do not damage the hybrid vehicle transaxle assembly type T oil seal.
Do not damage the front axle inboard joint boot.
Make sure to center the front drive shaft assembly LH during installation to prevent damage to the front drive shaft hole snap ring LH.
Confirm whether the drive shaft is securely driven in by checking the reaction force and sound.
| *a | Matchmark |
Align the matchmarks and install the front drive shaft assembly LH to the front axle hub sub-assembly.
Be careful not to damage the front axle outboard joint boot or speed sensor rotor.
43410
2.INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
Coat the spline of the front drive inboard joint assembly with ATF WS.
Coat the lip of the hybrid vehicle transaxle assembly type T oil seal with MP grease.
Install a new bearing bracket hole snap ring to the front drive shaft assembly RH.
Install the front drive shaft assembly RH.
Do not damage the hybrid vehicle transaxle assembly type T oil seal.
Do not damage the front axle inboard joint boot.
When inserting the front drive shaft assembly RH, keep it level.
Install the bearing bracket hole snap ring and a new bolt.
| *a | Matchmark |
Align the matchmarks and install the front drive shaft assembly RH to the front axle hub sub-assembly.
Be careful not to damage the front axle outboard joint boot or speed sensor rotor.
48069
3.CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
45470
4.CONNECT TIE ROD ASSEMBLY
89543
5.INSTALL FRONT SPEED SENSOR
48810
6.INSTALL FRONT STABILIZER LINK ASSEMBLY
43502H
7.INSTALL FRONT AXLE SHAFT NUT
Clean the threaded parts on the front drive shaft assembly and a new axle shaft nut using a non-residue solvent.
Be sure to perform this work even when using a new drive shaft.
Keep the threaded parts free of oil and foreign matter.
Using a socket wrench (30 mm), install the front axle shaft nut.
Using a chisel and a hammer, stake the front axle shaft nut.
8.INSTALL FRONT WHEELS
9.ADD HYBRID TRANSAXLE FLUID
10.INSPECT HYBRID TRANSAXLE FLUID
53737B
11.INSTALL FRONT FENDER APRON SEAL LH
53736
12.INSTALL FRONT FENDER APRON SEAL RH
51442C
13.INSTALL ENGINE UNDER COVER LH
53852K
14.INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
51441C
15.INSTALL ENGINE UNDER COVER RH
53851Z
16.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
17.ADJUST FRONT WHEEL ALIGNMENT
18.CHECK FOR SPEED SENSOR SIGNAL