Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR
RM2040EQ _54 Brake _014708 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0074981 FRONT SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.

·

If the sensor rotor needs to be replaced, replace the front drive outboard joint shaft assembly.



PROCEDURE

Hide 89543 1.INSTALL FRONT SPEED SENSOR

a.

Install the front speed sensor to the steering knuckle with the bolt.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:
·

Prevent foreign matter from attaching to the front speed sensor tip.

·

Firmly insert the front speed sensor body into the steering knuckle before tightening the bolt.

·

After installing the front speed sensor to the steering knuckle, make sure that there is no clearance between the front speed sensor stay and steering knuckle. Also make sure that no foreign matter is stuck between the parts.




b.
C238449C08
1.479,0.302 1.688,0.302 false 0.979,0.813 0.823,0.813 0.823,0.813 0.698,1.073 false 1.198,0.667 0.438,0.302 0.438,0.302 1.135,0.813 false 1.729,0.208 1.958,0.448 0.229,0.24 10 false *1 0.542,1.021 0.771,1.25 0.229,0.229 10 false *2 0.271,0.188 0.51,0.406 0.24,0.219 10 false *a
*1 Front Speed Sensor Clamp
*2 Front Flexible Hose
*a Claw


Install the front speed sensor clamp and front flexible hose to the shock absorber bracket with the bolt.

Torque:
19 N*m (192 kgf*cm, 14 ft.*lbf)

NOTICE:
·

Do not twist the wire harness for the front speed sensor when installing it.

·

Securely set the 2 claws of the front speed sensor clamp to the shock absorber bracket.

·

A bolt tightens the brake flexible hose and front speed sensor together. Make sure that the front flexible hose is positioned over the front speed sensor.




c.

Engage the clamp to the front shock absorber.


d.
C238450C04
1.604,1.813 1.177,1.813 false 1.01,1.719 1.24,1.927 0.229,0.208 10 false *a
*a Claw


Install the speed sensor clamp to the body with the bolt.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:
·

Do not twist the wire harness for the front speed sensor when installing it.

·

Securely set the claw of the front speed sensor clamp to the body.




e.

Engage the clamp and connect the connector.


Hide 53876A 2.INSTALL FRONT FENDER LINER

HINT:

Use the same procedure for the LH side and RH side.

Click hereVehicle Exterior>WIPER / WASHER>WASHER MOTOR>INSTALLATION


Hide 3.CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL