Home › Brake › BRAKE (REAR) › REAR BRAKE FLEXIBLE HOSE
RM2040EQ _54 Brake _014711 BRAKE (REAR) _0074993 REAR BRAKE FLEXIBLE HOSE A

BRAKE (REAR)  REAR BRAKE FLEXIBLE HOSE  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Because the left and right rear flexible hoses are not interchangeable, verify the part number when installing the flexible hoses.

·

If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.



HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 47319F 1.INSTALL REAR FLEXIBLE HOSE

a.
C243121C08
1.896,1 2.469,1.563 2.469,1.563 2.667,1.563 false 2.688,1.469 2.958,1.729 0.271,0.26 10 false *a
*a Lock Hole


Connect the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and a new gasket.

Torque:
33 N*m (340 kgf*cm, 25 ft.*lbf)

NOTICE:

Install the flexible hose lock securely into the lock hole in the disc brake cylinder.



b.

Install the rear flexible hose with a bolt.

Torque:
19 N*m (192 kgf*cm, 14 ft.*lbf)


c.

Install a new clip.

NOTICE:

Install the clip as far as it will go.



d.

Using a union nut wrench, connect the brake line to the rear flexible hose while holding the rear flexible hose with a wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not bend or damage the brake line.

·

Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.

·

Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




Hide 2.CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

Hide 55702A 4.INSTALL FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY

Hide 5.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 6.INSTALL REAR WHEEL

Torque:
103 N*m (1049 kgf*cm, 76 ft.*lbf)