89170
1.INSTALL AIRBAG SENSOR ASSEMBLY
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
| *a | Fulcrum Length |
Using SST, install the airbag sensor assembly with the 3 bolts.
Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
This torque value is effective when SST is parallel to a torque wrench.
If the airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
When installing the airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
When the power switch is first turned on (IG) after the airbag sensor assembly has been replaced, make sure that no one is in the vehicle.
| *1 | Waterproof Sheet |
Connect the connectors to the airbag sensor assembly as shown in the illustration.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Check that the waterproof sheet is properly set.
Check that there is no looseness in the installation parts of the airbag sensor assembly.
58861B
2.INSTALL NO. 1 CONSOLE BOX DUCT
58543B
3.INSTALL FLOOR CARPET BRACKET RH
58544A
4.INSTALL FLOOR CARPET BRACKET LH
58816B
5.INSTALL CONSOLE BOX INSERT
58817A
6.INSTALL FRONT NO. 2 CONSOLE BOX INSERT
58804A
7.INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
58916
8.INSTALL BOX BOTTOM MAT
55432D
9.INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
53601
10.CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
55317A
11.INSTALL INSTRUMENT SIDE PANEL RH
62311B
12.CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
62111A
13.INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
67913
14.INSTALL FRONT DOOR SCUFF PLATE RH
55303B
15.INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
55607
16.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55318C
17.INSTALL INSTRUMENT SIDE PANEL LH
62312B
18.CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
62112A
19.INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
Use the same procedure for the LH side and RH side (Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION).
67914
20.INSTALL FRONT DOOR SCUFF PLATE LH
Use the same procedure for the LH side and RH side (Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION).
21.INSTALL REAR CONSOLE BOX ASSEMBLY
22.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
64718C
23.INSTALL LUGGAGE TRIM SERVICE HOLE COVER
24. PERFORM DIAGNOSTIC SYSTEM CHECK
25.INSPECT SRS WARNING LIGHT
26. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION
When the airbag sensor assembly is replaced, perform zero point learning for the yaw rate and acceleration sensor (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>CALIBRATION).
The yaw rate and acceleration sensor is built into the airbag sensor assembly.