73480
1.INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH
73480
2.INSTALL REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH
Engage the guide to temporarily install the rear seat inner with center belt assembly LH.
Install the bolt.
Check if the ELR locks.
The check should be performed with the rear seat inner with center belt assembly LH installed.
With the belt assembly installed, check that the belt locks when it is pulled out quickly.
64330
3.INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade)
64330
4.INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade)
73373
5.INSTALL REAR SEAT SHOULDER BELT COVER
62471A
6.INSTALL ROOF SIDE INNER GARNISH RH
62472A
7.INSTALL ROOF SIDE INNER GARNISH LH
Use the same procedure as for the RH side.
62331A
8.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH
62332A
9.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
73360C
10.CONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH
73370C
11.CONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
12.INSTALL REAR SIDE SEATBACK ASSEMBLY LH
13.INSTALL REAR SIDE SEATBACK ASSEMBLY RH
73480
14.CONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH
| *1 | Protruding Part |
Connect the floor anchor of the rear seat inner with center belt assembly LH with the bolt.
Install the rear seat inner with center belt assembly LH with the arrow on the anchor part facing the front of the vehicle.
Do not allow the anchor part of the rear seat inner with center belt assembly LH to overlap the protruding parts of the floor panel.
Engage the clamp.
Connect the connector.
73470B
15.INSTALL REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH
| *1 | Protruding Part |
Install the rear seat inner with center belt assembly RH with the bolt.
Install the rear seat inner with center belt assembly RH with the arrow on the anchor part facing the front of the vehicle.
Do not allow the anchor part of the rear seat inner with center belt assembly RH to overlap the protruding parts of the floor panel.
Engage the clamp.
Connect the 2 connectors.
72693
16.INSTALL REAR SEAT CUSHION LOCK HOOK
17.INSTALL REAR SEAT CUSHION ASSEMBLY