The skid control ECU detects a drop in accumulator pressure according to the signals from the accumulator pressure sensor, then operates and stops the motor relay as well as the pump motor.
The skid control ECU troubleshoots the built-in motor relay drive circuit, and stores this DTC when a malfunction is detected.
| DTC No. | Detection Item | INF Code | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|---|
| C1257/57 | Power Supply Drive Circuit | 361
362 |
·
INF Code: 361 ·
While accumulator pressure falls below hard pump ON pressure, the hard drive circuit does not operate for 1 second or more. ·
INF Code: 362 ·
When hard driving, one of the 3 built-in motor relays does not operate for 0.2 seconds or more. |
Skid control ECU (Brake booster with master cylinder assembly) | Electronically controlled brake system DTC |
When replacing the skid control ECU (brake booster with master cylinder assembly), perform initialization and calibration of the linear solenoid valve.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION
When C1241/41, C1242/42 and/or C1253/53 are output together with C1257/57, inspect and repair the trouble areas indicated by C1241/41, C1242/42 and/or C1253/53 first.
for C1241/41 and C1242/42: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>C1241/41
for C1253/53: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>C1252/52
Replace the skid control ECU (brake booster with master cylinder assembly).
| Proceed to |
|---|
| NEXT |
NEXT