Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › BATTERY COOLING DUCT(w/ Filter) › 2015.04–2016.05
RM2040EQ _51 Engine / Hybrid System _014692 HYBRID / BATTERY CONTROL _0109199 BATTERY COOLING DUCT(w/ Filter) A

HYBRID / BATTERY CONTROL  BATTERY COOLING DUCT(w/ Filter)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL NO. 1 HYBRID BATTERY INTAKE FILTER

a.
A318968

Install the No. 1 hybrid battery intake filter to the No. 1 hybrid battery intake duct.

NOTICE:
A308345C01
0.802,1.896 0.385,1.896 false 1.906,0.865 1.865,0.656 false 0.25,0.521 0.479,0.698 0.229,0.177 10 false *a 0.844,1.833 1.073,2.01 0.229,0.177 10 false *b 1.875,0.885 2.104,1.063 0.229,0.177 10 false *b
*a Cross Section View of No. 1 Hybrid Battery Intake Duct
*b Rubber Portion of No. 1 Hybrid Battery Intake Filter


Make sure the rubber portion of the No. 1 hybrid battery intake filter is behind the points shown in the illustration.



b.
A318969C02
2.188,1.875 2.604,1.385 true 2.667,0.885 2.365,0.75 false 3.146,1.104 2.896,1.354 true 2.073,1.906 2.292,2.083 0.219,0.177 10 false *a 2.188,0.667 2.604,1.135 0.417,0.469 10 false *a 3.167,1.021 3.396,1.281 0.229,0.26 10 false *a
*a Tape


Apply 3 pieces of tape as shown in the illustration to secure the No. 1 hybrid battery intake filter to the No. 1 hybrid battery intake duct.

HINT:

If the adhesion of the tape is weak, replace it with new tape.



Hide 2.INSTALL REAR SIDE SEATBACK ASSEMBLY LH

Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY>INSTALLATION

HINT:
A347556C01
2.229,2.031 2.531,1.083 2.531,1.083 2.802,1.083 true 2.854,0.969 3.167,1.323 0.313,0.354 10 false *a
*a Intake Port


After installing the rear side seatback assembly LH, look through the intake port and make sure that the No. 1 hybrid battery intake filter is securely installed to the No. 1 hybrid battery intake duct.


Hide 72693 4.INSTALL REAR SEAT CUSHION LOCK HOOK

Hide 5.INSTALL REAR SEAT CUSHION ASSEMBLY

Hide 6. CLEAR DTC

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>DTC CHECK / CLEAR

HINT:

If the message "Cooling performance of the hybrid battery is low Consult a dealer" is displayed on the multi-information display, clean or replace the No. 1 hybrid battery intake filter, and clear the DTCs to reset the learning values even if no DTCs are output.