The main body ECU (multiplex network body ECU) determines the condition of the automatic high beam system based on automatic high beam system signals from the lane departure warning camera. If a DTC is stored for a malfunction in a related system, the main body ECU (multiplex Network Body ECU) stores this DTC simultaneously.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B124B | Automatic High Beam System | Any DTC related to the following malfunctions is stored:
·
Wheel speed sensor malfunction ·
Yaw rate sensor malfunction ·
CAN communication malfunction |
·
Electronically controlled brake system ·
EFI system ·
CAN communication system ·
Lane departure warning camera ·
Main body ECU (multiplex network body ECU) |
Confirm that there are no CAN communication system malfunctions before performing the following inspection.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: System Select / Health Check.
Check for DTCs.
| Result | Proceed to |
|---|---|
| Only DTC B124B is output | A |
| DTC B124B and other DTCs are output | B |
A
B
Check if a lane departure alert system warning message is displayed on the multi-information display.
No lane departure alert system warning message are displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
See page xxx
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
NG