Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR BELT MOULDING › from 2015.04
RM2040EQ _59 Vehicle Exterior _014740 EXTERIOR PANELS / TRIM _0075193 FRONT DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  FRONT DOOR BELT MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 4.REMOVE MIRROR SUB-ASSEMBLY WITH COVER

Hide 67832 5.REMOVE FRONT DOOR SERVICE HOLE COVER

Hide 68102 6.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

Hide 75720 7.REMOVE FRONT DOOR BELT MOULDING ASSEMBLY

a.
B380981C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the front door belt moulding assembly as shown in the illustration.


b.
B380982C01
1.583,1.083 1.438,1.021 false 1.615,1 1.927,1.156 0.313,0.156 10 false *a
*a Screwdriver
V100155

Protective Tape


Using a screwdriver with its tip wrapped with protective tape, disengage the 5 claws as shown in the illustration and remove the front door belt moulding assembly.