Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR BELT MOULDING › from 2015.04
RM2040EQ _59 Vehicle Exterior _014740 EXTERIOR PANELS / TRIM _0075193 FRONT DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  FRONT DOOR BELT MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 75720 2.INSTALL FRONT DOOR BELT MOULDING ASSEMBLY

a.
B380983

Engage the 5 claws to install the front door belt moulding assembly.


Hide 68102 3.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

Hide 67832 4.INSTALL FRONT DOOR SERVICE HOLE COVER

Hide 5.INSTALL MIRROR SUB-ASSEMBLY WITH COVER

Hide 6.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 7.INSTALL LUGGAGE TRIM SERVICE HOLE COVER

Hide 8.INITIALIZE POWER WINDOW CONTROL SYSTEM