Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR BELT MOULDING › from 2015.04
RM2040EQ _59 Vehicle Exterior _014740 EXTERIOR PANELS / TRIM _0075194 REAR DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR BELT MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 75740 2.INSTALL REAR DOOR BELT MOULDING ASSEMBLY

a.
B380986

Engage the 6 claws to install the rear door belt moulding assembly.


Hide 68104 3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 68124B 4.INSTALL REAR DOOR QUARTER WINDOW GLASS

Hide 67408F 5.INSTALL REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

Hide 68152C 6.INSTALL REAR DOOR GLASS RUN

Hide 67872 7.INSTALL REAR DOOR WEATHERSTRIP

Hide 68640A 8.INSTALL REAR DOOR CHECK ASSEMBLY

Hide 67842E 9.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 68174A 10.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

Hide 67604 11.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74260 12.INSTALL REAR ARMREST ASSEMBLY

Hide 13.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 69284D 14.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

Hide 15.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 16.INSTALL LUGGAGE TRIM SERVICE HOLE COVER