Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BLACK OUT TAPE(for Rear Door) › from 2015.04
RM2040EQ _59 Vehicle Exterior _014740 EXTERIOR PANELS / TRIM _0075201 BLACK OUT TAPE(for Rear Door) A

EXTERIOR PANELS / TRIM  BLACK OUT TAPE(for Rear Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 75978H 3.INSTALL REAR DOOR LOWER OUTSIDE STRIPE

a.

Refer to the illustration to position a new rear door lower outside stripe.

B381006C01
4.771,0.823 5.031,0.667 true 4.979,1.583 5.229,1.667 true 4.729,2.615 5.021,2.833 true 5.958,2.635 5.656,2.729 true 4.104,2.26 4.5,2.667 0.396,0.406 12 false *A 5.438,2.26 5.833,2.583 0.396,0.323 12 false *B 5.042,2.729 5.417,3.042 0.375,0.313 10 false *b 5.5,2.656 5.865,2.938 0.365,0.281 10 false *c 4.083,0.083 4.5,0.49 0.417,0.406 10 false a-a 4.74,0.031 5.073,0.448 0.333,0.417 10 false A 4.958,2.052 5.292,2.469 0.333,0.417 10 false B 5.031,0.531 5.385,0.792 0.354,0.26 10 false *a 5.229,1.594 5.583,1.854 0.354,0.26 10 false *a 2.594,2.677 3.01,3.083 0.417,0.406 10 false a 3.198,2.583 3.615,2.99 0.417,0.406 10 false a
*A LH Side *B RH Side
*a Edge of Curved Surface *b Straight
*c Triangle - -


Standard Measurement:
Area Measurement Area Measurement
A 1.5 mm (0.0591 in.) B 1.0 mm (0.0394 in.)



b.

Remove the release paper and install the rear door lower outside stripe.


Hide 75988C 4.INSTALL REAR DOOR OUTSIDE STRIPE

a.

Refer to the illustration to position a new rear door outside stripe.

B381007C01
4.833,1.25 5.021,1.323 true 5.802,1.042 5.938,0.781 true 4.927,2.948 5.156,2.802 true 5.979,2.948 5.698,2.792 true 4.083,2.25 4.583,2.667 0.5,0.417 12 false *A 5.479,2.281 5.979,2.698 0.5,0.417 12 false *B 4.667,1.167 5.031,1.531 0.365,0.365 10 false *a 5.156,2.708 5.51,2.958 0.354,0.25 10 false *b 5.552,2.688 5.865,2.844 0.313,0.156 10 false *c 0,0.781 0.156,0.938 0.156,0.156 10 false - 5.927,0.646 6.292,1.01 0.365,0.365 10 false *a 1.563,1.615 1.813,1.885 0.25,0.271 10 false a 1.563,2.208 1.813,2.479 0.25,0.271 10 false a 4.292,0.188 4.698,0.594 0.406,0.406 10 false a-a 6.49,0.625 6.844,1 0.354,0.375 10 false A 4.323,1.594 4.677,1.969 0.354,0.375 10 false B
*A LH Side *B RH Side
*a Edge of Curved Surface *b Straight
*c Triangle - -


Standard Measurement:
Area Measurement Area Measurement
A 1.5 mm (0.0591 in.) B 1.0 mm (0.0394 in.)



b.

Remove the release paper and install the rear door outside stripe.


Hide 5.INSTALL NO. 2 BLACK OUT TAPE

a.

Refer to the illustration to position a new No. 2 black out tape.

B381008C01
4.729,1.302 5,1.458 true 5.76,1.177 5.969,0.854 true 4.135,2.99 4.365,3.208 true 6.51,2.958 6.271,3.229 true 4.042,2.25 4.5,2.583 0.458,0.333 12 false *A 5.604,2.208 6,2.667 0.396,0.458 12 false *B 4.552,1.188 4.958,1.521 0.406,0.333 10 false *a 4.406,3.167 4.781,3.49 0.375,0.323 10 false *b 6.188,3.24 6.542,3.552 0.354,0.313 10 false *c 0.385,2.167 0.688,2.51 0.302,0.344 10 false a 0.698,2.667 1,3.01 0.302,0.344 10 false a 6.458,0.75 6.865,1.156 0.406,0.406 10 false A 4.323,1.708 4.729,2.115 0.406,0.406 10 false B 4.198,0.344 4.604,0.75 0.406,0.406 10 false a-a 6,0.74 6.406,1.073 0.406,0.333 10 false *a
*A LH Side *B RH Side
*a Edge of Curved Surface *b Straight
*c Triangle - -


Standard Measurement:
Area Measurement Area Measurement
A 1.5 mm (0.0591 in.) B 1.0 mm (0.0394 in.)



b.

Remove the release paper and install the No. 2 black out tape.


Hide 67674A 6.INSTALL REAR DOOR FRAME GARNISH

Hide 68104 7.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 68124B 8.INSTALL REAR DOOR QUARTER WINDOW GLASS

Hide 67408F 9.INSTALL REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

Hide 68152C 10.INSTALL REAR DOOR GLASS RUN

Hide 67872 11.INSTALL REAR DOOR WEATHERSTRIP

Hide 68640A 12.INSTALL REAR DOOR CHECK ASSEMBLY

Hide 67842E 13.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 68174A 14.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

Hide 67604 15.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74260 16.INSTALL REAR ARMREST ASSEMBLY

Hide 17.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 69284D 18.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

Hide 19.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 20.INSTALL LUGGAGE TRIM SERVICE HOLE COVER