This DTC is stored when the combination meter assembly detects a fuel sender gauge malfunction via a direct line.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1500 | Fuel Sender Open Detected | When IG voltage is 9.5 V or more and the following condition is detected:
1.
Fuel sender gauge operation malfunction |
·
Harness or connector ·
Fuel sender gauge assembly ·
Combination meter assembly |
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Fuel Input | Fuel input signal | Min.: 0 L, Max.: 127.5 L | Fuel receiver gauge indicates F: 57.0
Fuel receiver gauge indicates 3/4: 46.5 Fuel receiver gauge indicates 1/2: 31.6 Fuel receiver gauge indicates 1/4: 14.8 Fuel receiver gauge indicates E: 5.5 |
Unit: Liter |
| Tester Display |
|---|
| Fuel Input |
| Result | Proceed to |
|---|---|
| Fuel level data can be displayed on the GTS and DTC B1500 is output. | A |
| Fuel level data cannot be displayed on the GTS. | B |
A
B
| *a | Front view of wire harness connector
(to Combination Meter Assembly) |
Disconnect the I18 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I18-14 (FR) - I18-15 (FE) | Always | 13.5 to 414.5 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the N11 fuel suction tube assembly with pump and gauge connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I18-14 (FR) - N11-2 (FS) | Always | Below 1 Ω |
| I18-14 (FR) - Body ground | Always | 10 kΩ or higher |
| I18-15 (FE) - N11-3 (FE) | Always | Below 1 Ω |
| I18-15 (FE) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the fuel sender gauge assembly.
Click hereEngine / Hybrid System>2AR-FXE FUEL>FUEL SENDER GAUGE ASSEMBLY>REMOVAL
Inspect the fuel sender gauge assembly.
Click hereEngine / Hybrid System>2AR-FXE FUEL>FUEL SENDER GAUGE ASSEMBLY>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Visually check for deformation on the fuel suction tube assembly with pump and gauge connector.
There is no deformation.
| Proceed to |
|---|
| OK |
| NG |
OK
NG