Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION RECEIVER(for SD) › from 2014.05
RM2040EQ _56 Audio / Visual / Telematics _014717 NAVIGATION / MULTI INFO DISPLAY _0169218 NAVIGATION RECEIVER(for SD) A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION RECEIVER(for SD)  INSTALLATION  


PROCEDURE

Hide 86120L 1.INSTALL NAVIGATION RECEIVER ASSEMBLY

Hide 55900 2.INSTALL AIR CONDITIONING CONTROL ASSEMBLY

Hide 86211 3.INSTALL NO. 1 RADIO BRACKET

a.

Install the No. 1 radio bracket with the 5 screws.


Hide 86212 4.INSTALL NO. 2 RADIO BRACKET

a.

Install the No. 2 radio bracket with the 5 screws.


Hide 5.INSTALL NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY

a.

Connect each connector.


b.

Engage the 8 clips to the vehicle body to temporarily install the navigation receiver assembly with air conditioning control assembly.


c.

Install the navigation receiver assembly with air conditioning control assembly with the 4 bolts.


Hide 55660 6.INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 7.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 58804A 8.INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

Hide 10.INSTALL REAR CONSOLE BOX ASSEMBLY

Hide 11.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 64718C 12.INSTALL LUGGAGE TRIM SERVICE HOLE COVER