Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY › from 2015.04
RM2040EQ _59 Vehicle Exterior _014735 DOOR / HATCH _0075150 HOOD LOCK CONTROL CABLE ASSEMBLY A

DOOR / HATCH  HOOD LOCK CONTROL CABLE ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 53630 1.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY

a.

Pass the hood lock control cable assembly into the engine compartment.


b.

Pass the cable through the upper radiator support.


c.

Engage the hood cable grommet.


d.

Engage the 4 clamps and install the hood lock control cable assembly.


Hide 53510 2.INSTALL HOOD LOCK ASSEMBLY

a.
B400613

Apply MP grease to the sliding areas of the lock.


b.

Connect the hood lock control cable assembly.


c.

Install the hood lock assembly with the 2 bolts and hood lock bolt.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

HINT:

The hood lock nut cap is a non-reusable part. Be sure to install it after performing the Inspect Hood Sub-assembly and Adjust Hood Sub-assembly steps.



d.

Connect the connector.


Hide 53601 3.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

a.

Connect the hood lock control cable assembly and install the hood lock control lever sub-assembly.


Hide 53601 4.CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Hide 62111A 5.INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

Hide 67913 6.INSTALL FRONT DOOR SCUFF PLATE RH

Hide 53875A 7.INSTALL FRONT FENDER LINER RH

Hide 53851Z 8.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

Hide 52611 10.INSTALL FRONT BUMPER ENERGY ABSORBER (w/o Dynamic Radar Cruise Control System)

Hide 11.INSTALL FRONT BUMPER ASSEMBLY (w/o Dynamic Radar Cruise Control System)

Hide 88211B 12.INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

Hide 53301 13.ADJUST HOOD SUB-ASSEMBLY