73900
1.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
| *1 | Airbag Connector |
| *2 | Airbag Connector Lock |
Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the lock to install the airbag connector.
Temporarily install the lower No. 1 instrument panel airbag assembly with the 2 hooks.
Engage the 2 claws to install the DLC3.
Install the 4 bolts.
Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.
2.INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL ASSEMBLY
53601
3.CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
55317A
4.INSTALL INSTRUMENT SIDE PANEL RH
62311B
5.CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
62111A
6.INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
67913
7.INSTALL FRONT DOOR SCUFF PLATE RH
8.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
64718C
9.INSTALL LUGGAGE TRIM SERVICE HOLE COVER
10. PERFORM DIAGNOSTIC SYSTEM CHECK
11.INSPECT SRS WARNING LIGHT