1.INSTALL NO. 1 HYBRID BATTERY INTAKE FILTER
Install the No. 1 hybrid battery intake filter to the No. 1 hybrid battery intake duct.
| *a | Cross Section View of No. 1 Hybrid Battery Intake Duct |
| *b | Rubber Portion of No. 1 Hybrid Battery Intake Filter |
Make sure the rubber portion of the No. 1 hybrid battery intake filter is behind the points shown in the illustration.
| *a | Tape |
Apply 3 pieces of tape as shown in the illustration to secure the No. 1 hybrid battery intake filter to the No. 1 hybrid battery intake duct.
If the adhesion of the tape is weak, replace it with new tape.
2.INSTALL REAR SIDE SEATBACK ASSEMBLY LH
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY>INSTALLATION
| *a | Intake Port |
After installing the rear side seatback assembly LH, look through the intake port and make sure that the No. 1 hybrid battery intake filter is securely installed to the No. 1 hybrid battery intake duct.
3.INSTALL REAR SEATBACK ASSEMBLY
72693
4.INSTALL REAR SEAT CUSHION LOCK HOOK
5.INSTALL REAR SEAT CUSHION ASSEMBLY
6. CLEAR DTC
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>DTC CHECK / CLEAR
If the message "Maintenance required for hybrid battery cooling parts at your dealer" is displayed on the multi-information display, clean or replace the No. 1 hybrid battery intake filter, and clear the DTCs to reset the learning values even if no DTCs are output.