DTC P0010 Camshaft Position "A" Actuator Circuit (Bank 1) |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0010 | Open or short in camshaft timing oil control valve assembly circuit (1 trip detection logic). |
|
| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.READ OUTPUT DTC (DTC P0010) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the tester on.
Clear the DTC after recording the freeze frame data and DTC.
Turn the power switch off and wait for at least 30 seconds.
Turn the tester on.
Put the engine in inspection mode (maintenance mode) (Click here).
Start the engine and allow the engine to idle.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC P0010 is output | A |
| DTC is not output | B |
|
| ||||
| A | |
| 2.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY |
Inspect the camshaft timing oil control valve assembly (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY - ECM) |
Disconnect the camshaft timing oil control valve assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E63-1 - E28-74 (OC1+) | Always | Below 1 Ω |
| E63-2 - E28-75 (OC1-) | Always | Below 1 Ω |
| E63-1 or E28-74 (OC1+) - Body ground | Always | 10 kΩ or higher |
| E63-2 or E28-75 (OC1-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||