ELECTRONICALLY CONTROLLED BRAKE SYSTEM > PROBLEM SYMPTOMS TABLE |
| Symptom | Suspected Area | See page |
| ABS, BA and/or EBD does not operate | Use a chassis dynamometer, etc. to check the electronically controlled brake system operation. | - |
| Check again to see if DTCs are output. (If DTCs are output, perform diagnosis based on the DTCs that are output.) |
Click here
| |
| Power source circuit |
Click here
| |
| Front speed sensor circuit |
Click here
| |
| Rear speed sensor circuit |
Click here
| |
| Check the brake actuator (brake booster with master cylinder assembly) using the intelligent tester. (Check brake actuator (brake booster with master cylinder assembly) operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks. |
Click here
| |
| If the symptoms still occur even after the above suspected areas have been inspected and proved to be normal, replace the skid control ECU (brake booster with master cylinder assembly) (for LHD). |
Click here
| |
| If the symptoms still occur even after the above suspected areas have been inspected and proved to be normal, replace the skid control ECU (brake booster with master cylinder assembly) (for RHD). |
Click here
| |
| ABS, BA and/or EBD does not operate efficiently | Check again to see if DTCs are output. (If DTCs are output, perform diagnosis based on the DTCs that are output.) |
Click here
|
| Front speed sensor circuit |
Click here
| |
| Rear speed sensor circuit |
Click here
| |
| Check the brake actuator (brake booster with master cylinder assembly) using the intelligent tester. (Check brake actuator (brake booster with master cylinder assembly) operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks. |
Click here
| |
| If the symptoms still occur even after the above suspected areas have been inspected and proved to be normal, replace the skid control ECU (brake booster with master cylinder assembly) (for LHD). |
Click here
| |
| If the symptoms still occur even after the above suspected areas have been inspected and proved to be normal, replace the skid control ECU (brake booster with master cylinder assembly) (for RHD). |
Click here
| |
| ABS warning light abnormal (Remains on) | ABS warning light circuit |
Click here
|
| Skid control ECU (Brake booster with master cylinder assembly) (for LHD) |
Click here
| |
| Skid control ECU (Brake booster with master cylinder assembly) (for RHD) |
Click here
| |
| ABS warning light abnormal (Does not come on) | ABS warning light circuit |
Click here
|
| Skid control ECU (Brake booster with master cylinder assembly) (for LHD) |
Click here
| |
| Skid control ECU (Brake booster with master cylinder assembly) (for RHD) |
Click here
| |
| Brake warning light / red (malfunction) abnormal (Remains on) | Brake fluid level warning switch circuit |
Click here
|
| Brake warning light / red (malfunction) circuit |
Click here
| |
| Skid control ECU (Brake booster with master cylinder assembly) (for LHD) |
Click here
| |
| Skid control ECU (Brake booster with master cylinder assembly) (for RHD) |
Click here
| |
| Brake warning light / red (malfunction) abnormal (Does not come on) | Brake warning light / red (malfunction) circuit |
Click here
|
| Skid control ECU (Brake booster with master cylinder assembly) (for LHD) |
Click here
| |
| Skid control ECU (Brake booster with master cylinder assembly) (for RHD) |
Click here
| |
| VSC and/or TRC does not operate | Check that traction control has not operated by carrying out diagnosis. | - |
| Check again to see if DTCs are output. (If DTCs are output, perform diagnosis based on the DTCs that are output.) |
Click here
| |
| Power source circuit |
Click here
| |
| Check the hydraulic circuit for leaks. | - | |
| Front speed sensor circuit |
Click here
| |
| Rear speed sensor circuit |
Click here
| |
| Yaw rate and acceleration sensor circuit |
Click here
| |
| Steering angle sensor circuit |
Click here
| |
| If the symptoms still occur even after the above suspected areas have been inspected and proved to be normal, replace the skid control ECU (brake booster with master cylinder assembly) (for LHD). |
Click here
| |
| If the symptoms still occur even after the above suspected areas have been inspected and proved to be normal, replace the skid control ECU (brake booster with master cylinder assembly) (for RHD). |
Click here
| |
| Brake warning light / yellow (minor malfunction) abnormal (Remains on) | Brake warning light / yellow (minor malfunction) circuit |
Click here
|
| Skid control ECU (Brake booster with master cylinder assembly) (for LHD) |
Click here
| |
| Skid control ECU (Brake booster with master cylinder assembly) (for RHD) |
Click here
| |
| Brake warning light / yellow (minor malfunction) abnormal (Does not come on) | Brake warning light / yellow (minor malfunction) circuit |
Click here
|
| Skid control ECU (Brake booster with master cylinder assembly) (for LHD) |
Click here
| |
| Skid control ECU (Brake booster with master cylinder assembly) (for RHD) |
Click here
| |
| Slip indicator light abnormal (Remains on) | Slip indicator light circuit |
Click here
|
| Skid control ECU (Brake booster with master cylinder assembly) (for LHD) |
Click here
| |
| Skid control ECU (Brake booster with master cylinder assembly) (for RHD) |
Click here
| |
| Slip indicator light abnormal (Does not come on) | Slip indicator light circuit |
Click here
|
| Skid control ECU (Brake booster with master cylinder assembly) (for LHD) |
Click here
| |
| Skid control ECU (Brake booster with master cylinder assembly) (for RHD) |
Click here
| |
| DTC check cannot be done | Check again to see if DTCs are output. (If DTCs are output, perform diagnosis based on the DTCs that are output.) |
Click here
|
| TC and CG terminal circuit |
Click here
| |
| If the symptoms still occur even after the above suspected areas has been inspected and proved to be normal, replace the skid control ECU (brake booster with master cylinder assembly) (for LHD). |
Click here
| |
| If the symptoms still occur even after the above suspected areas has been inspected and proved to be normal, replace the skid control ECU (brake booster with master cylinder assembly) (for RHD). |
Click here
| |
| Sensor check cannot be done | TS and CG terminal circuit |
Click here
|
| Skid control ECU (Brake booster with master cylinder assembly) (for LHD) |
Click here
| |
| Skid control ECU (Brake booster with master cylinder assembly) (for RHD) |
Click here
| |
| Meter buzzer abnormal | Meter buzzer circuit |
Click here
|
| Skid control ECU (Brake booster with master cylinder assembly) (for LHD) |
Click here
| |
| Skid control ECU (Brake booster with master cylinder assembly) (for RHD) |
Click here
|