Home › Vehicle Interior › SEAT › FRONT POWER SEAT CONTROL SYSTEM (w/ Memory)

FRONT POWER SEAT CONTROL SYSTEM (w/ Memory) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedure to troubleshoot the front power seat control system.

  1. *: Use the GTS.


1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer to confirm the trouble (Click here).


    NEXT


    3.INSPECT BATTERY VOLTAGE
    1. Measure the vehicle battery voltage.

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


    NEXT


    4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the GTS to check if the CAN communication system is functioning normally (Click here).

      Result:
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B



    B.
    Go to CAN COMMUNICATION SYSTEM (Click here)
    A


    5.CHECK FOR DTC*
    1. Check for DTCs and note any codes that are output (Click here).

    2. Clear the DTCs.

    3. Recheck for DTCs.

      Result:
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    Go to DIAGNOSTIC TROUBLE CODE CHART (Click here)
    A


    6.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

    2. Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B



    B.
    Go to step 8
    A


    7.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation Check (Click here)

    2. Data List / Active Test (Click here)

    3. Terminals of ECU (Click here)


    NEXT


    8.REPAIR OR REPLACE

      NEXT


      9.CONFIRMATION TEST

        NEXT

        END