Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › SMART ENTRY AND START SYSTEM (for Start Function)

SMART ENTRY AND START SYSTEM (for Start Function) > DIAGNOSTIC TROUBLE CODE CHART

for Preparation Click here



Smart Entry and Start System (for Start Function) 
DTC Code
Detection Item
DTC Output Confirmation Operation
See page
B2271
Ignition Hold Monitor Malfunction
IG ON
Click here
B2274
ACC Monitor Malfunction
Wait 10 seconds after turning the engine switch on (ACC) or on (IG), and then wait another 10 seconds after turning the engine switch off.
Click here
B2277
Detecting Vehicle Submersion
Wait 300 seconds after connecting the cable to the negative (-) battery terminal.
Click here
B2282
Vehicle Speed Signal Malfunction
Drive the vehicle for 20 seconds at a vehicle speed of 25 km/h (16 mph) or more, and then drive the vehicle at a vehicle speed of less than 5 km/h (3 mph) for 20 seconds.
Click here
B2283
Vehicle Speed Sensor Malfunction
Run the engine at an engine speed of 2000 rpm or more for 330 seconds.
Click here
B2284
Brake Signal Malfunction
Connect the cable to the negative (-) battery terminal, release the brake pedal and wait 20 seconds or more. Then depress the brake pedal for 20 seconds
or more.
Click here
B2285
Steering Lock Position Signal Circuit Malfunction
Disconnect the cable from the negative (-) battery terminal, wait 30 seconds and then reconnect the cable to the negative (-) battery terminal. Wait 40 seconds or more with the engine switch off (with the steering wheel locked), then turn the engine switch on (ACC) (with the steering unlocked) and wait 40 seconds or more.
Click here
B2286
Runnable Signal Malfunction
Disconnect the cable from the negative (-) battery terminal, wait 30 seconds and reconnect the cable to the negative (-) battery terminal. Wait 20 seconds or more with the engine switch off, then start the engine and maintain an engine speed of 1000 rpm or more for 20 seconds or more.
Click here
P0335
Crankshaft Position Sensor Circuit Malfunction (NE Signal)
Allow the engine to idle for 10 seconds or more.
Click here
U0100
Lost Communication with ECM / PCM
Turn the engine switch on (IG) and wait 10 seconds or more.
Click here
U0140
Lost Communication with Main Body ECU
Always
Click here
U0142
Lost Communication with Main Body ECU
Always
Click here
U0155
Lost Communication with Combination Meter
Turn the engine switch on (IG) and wait 10 seconds or more.
Click here