TIRE PRESSURE WARNING SYSTEM > Tire Pressure Warning Light Circuit |

| 1.CHECK FOR DTC (CAN COMMUNICATION SYSTEM) |
Check if CAN communication system DTCs are output (Click here).
| Result | Proceed to |
| DTCs are not output. | A |
| DTCs are output. | B |
|
| ||||
| A | |
| 2.CHECK DTC OUTPUT (B1247) |
Clear the DTCs (Click here).
Turn the engine switch off.
Turn the engine switch on (IG).
Check for DTCs (Click here).
|
| ||||
| OK | |
| 3.CHECK OPERATION OF TIRE PRESSURE WARNING LIGHT (ACTIVE TEST) |
Turn the engine switch off.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Check the condition of the tire pressure warning light using the GTS.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. Tire Pressure Warning System | Tire pressure warning light | OFF or ON | - |
|
| ||||
| OK | ||
| ||