DTC P074015 Torque Converter Clutch Circuit Short to Battery or Open |
| DTC No. | DTC Detection Condition | Trouble Area |
| P074015 | 1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
|
|
| 1.CHECK HARNESS AND CONNECTOR (SHIFT SOLENOID VALVE SL CIRCUIT) |
Disconnect the E96 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E96-75 (SL) - Body ground | 20°C (68°F) | 11 to 15 Ω |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (ECM - WIRING HARNESS CONNECTOR) |
Disconnect the E8 connector from the wiring harness connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E96-75 (SL) - E8-6 (SL) | Always | Below 1 Ω |
| E96-75 (SL) - Other terminals | Always | 10 kΩ or higher |
| E8-6 (SL) - Other terminals | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SL) |
![]() |
Remove the wiring harness connector.
| *a | Component without harness connected (Transmission Wire) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A-6 (SL) - Body ground | 20°C (68°F) | 11 to 15 Ω |
|
| ||||
| OK | ||
| ||
| 4.INSPECT SHIFT SOLENOID VALVE SL |
![]() |
Remove the shift solenoid valve SL.
| *1 | Shift Solenoid Valve SL |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Solenoid Connector (SL) - Solenoid Body (SL) | 20°C (68°F) | 11 to 15 Ω |
|
| ||||
| OK | ||
| ||