ENGINE SWITCH > INSTALLATION |
| 1. INSTALL ENGINE SWITCH |
Engage the 2 claws to install the engine switch.
| 2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY |
for LHD with Smart Entry and Start System:
Connect the connector.
Engage the 3 clips and guide to install the lower instrument panel finish panel assembly.
| 3. INSTALL FRONT NO. 2 CONSOLE BOX INSERT |
![]() |
Engage the clip and 4 guides as shown in the illustration.
Install the front No. 2 console box insert with the 2 screws <C>.
for LHD:
Engage the 2 claws to connect the room temperature sensor.
| 4. INSTALL CONSOLE BOX ASSEMBLY |
| 5. INSTALL FRONT ASH RECEPTACLE ASSEMBLY |
Connect each connector.
![]() |
Engage the 2 clips.
Install the front ash receptacle assembly with the 2 screws <C>.
| 6. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY |
w/o Driver Side Knee Airbag:
Engage the 5 clips and 3 guides.
w/ Driver Side Knee Airbag:
Engage the 4 claws, 7 clips and 3 guides.
Install the instrument panel sub-assembly with the 2 bolts <B>.
| 7. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
Engage the claw and 2 guides to connect the hood lock control lever sub-assembly.
| 8. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
![]() |
Temporarily install the instrument cluster finish panel assembly as shown in the illustration.
Connect each connector.
for LHD:
Engage the 3 claws, 7 clips and 4 guides.
for RHD:
Engage the 4 claws, 5 clips and 4 guides.
![]() |
Engage the 4 clips and 2 guides to install the instrument cluster finish panel assembly.
| 9. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY |
![]() |
Engage the 4 clips to install the No. 1 instrument panel register assembly.
| 10. INSTALL INSTRUMENT SIDE PANEL LH |
Engage the 3 guides.
![]() |
Engage the 4 claws to install the instrument side panel LH as shown in the illustration.
| 11. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
![]() |
Align the alignment mark (Yellow) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the front door opening trim weatherstrip LH.
| *1 | Alignment Mark (Yellow) |
| 12. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH |
Engage the 2 clips.
Install the cowl side trim sub-assembly LH with the clip.
| 13. INSTALL FRONT DOOR SCUFF PLATE LH |
Engage the 10 claws to install the front door scuff plate LH.
| 14. INSTALL RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (w/o Navigation System) |
| 15. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (w/ Navigation System) |
| 16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |