LIGHTING SYSTEM > Engine Switch Illumination Circuit |

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Active Test.
Check that the illumination operates.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Illuminated Entry System | Engine switch illumination | ON/OFF | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT ENGINE SWITCH |
Remove the engine switch (Click here for 2AR-FE, Click here for 2GR-FE, Click here for 6AR-FSE).
Inspect the engine switch (Click here for 2AR-FE, Click here for 2GR-FE, Click here for 6AR-FSE).
| Result | Proceed to |
| OK | A |
| NG (for 2AR-FE) | B |
| NG (for 2GR-FE) | C |
| NG (for 6AR-FSE) | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (ENGINE SWITCH - CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)) |
Disconnect the I78 certification ECU (smart key ECU assembly) connector.
Disconnect the I58 engine switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I58-9 (SWIL) - I78-16 (SWIL) | Always | Below 1 Ω |
| I58-6 (AGND) - I78-24 (AGND) | Always | Below 1 Ω |
| I58-9 (SWIL) - Body ground | Always | 10 kΩ or higher |
| I58-6 (AGND) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||