Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Front Door Windows)

POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Front Door Windows) > Power Windows do not Operate Using All Window Switch

for Preparation Click here


DESCRIPTION

The power windows operate by using the power window regulator master switch assembly, power window regulator switch assembly or rear power window regulator switch assembly (for LH door or RH door).
The power window regulator master switch assembly, power window regulator switch assembly and rear power window regulator switch assemblies (for LH door or RH door) connect the same power supply and ground lines.

WIRING DIAGRAM

Refer to System Diagram (Click here).

INSPECTION PROCEDURE

NOTICE:
  1. The power window control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly (Click here).
  2. Inspect the fuses for circuits related to this system before performing the following inspection procedure.
  3. If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.

1.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY - BATTERY AND BODY GROUND)
B276330E51
  1. Disconnect the K15 power window regulator master switch assembly connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    K15-3 (B) - Body ground
    Always
    11 to 14 V
    K15-13 (PWS) - Body ground
    Engine switch on (IG)
    11 to 14 V

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K15-1 (GND) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Power Window Regulator Master Switch Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
  1. Replace the power window regulator master switch assembly (Click here).


NEXT


3.CHECK POWER WINDOW CONTROL SYSTEM
  1. Check the operation of the power windows by using the power window regulator master switch assembly, power window regulator switch assembly and rear power window regulator switch assemblies (for LH door or RH door) (Click here).

    OK:
    All power windows operate normally.



NG
Go to step 4
OK

END (POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WAS DEFECTIVE) 

4.REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
  1. Replace the main body ECU (multiplex network body ECU) (Click here).


NEXT


5.CHECK POWER WINDOW CONTROL SYSTEM
  1. Check the operation of the power windows by using the power window regulator master switch assembly, power window regulator switch assembly and rear power window regulator switch assemblies (for LH door or RH door) (Click here).

    OK:
    All power windows operate normally.



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (Click here)
OK

END (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) WAS DEFECTIVE)