POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Front Door Windows) > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| What | Vehicle model, system name |
| When | Date, time, occurrence frequency |
| Where | Road conditions |
| Under what conditions? | Driving conditions, weather conditions |
| How did it happen? | Problem symptoms |
| |||||
| 3.PRE-CHECK |
Measure the battery voltage.
Check the fuses and relays.
Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.
| |||||
| 4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Using the GTS, check for CAN communication system DTCs (Click here).
| Result | Proceed to |
| CAN DTCs are not output | A |
| CAN DTCs are output | B |
|
| ||||
| |||||
| 5.CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM* |
Using the GTS, check for LIN communication system DTCs (Click here).
| Result | Proceed to |
| LIN DTCs are not output | A |
| LIN DTCs are output | B |
|
| ||||
| |||||
| 6.CHECK FOR DTC* |
Check for DTCs and make a note of any codes that are output (Click here).
Clear the DTCs.
Recheck for DTCs.
| Result | Proceed to |
| DTCs are not output | A |
| DTCs are output | B |
|
| ||||
| |||||
| 7.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
|
| ||||
| |||||
| 8.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Operation Check (Click here)
Terminals of ECU (Click here)
Data List / Active Test (Click here)
Fail-safe Chart (Click here)
Inspection
| |||||
| 9.ADJUST, REPAIR OR REPLACE |
Check if any of the front door window regulators, power window regulator motor assembly (for driver door) or power window regulator motor assembly (for front passenger door), door glass or door glass runs have been removed and reinstalled.
| Result | Proceed to |
| Any of the door window regulators, power window regulator motor assembly (for driver door) or power window regulator motor assembly (for front passenger door), door glass or door glass runs have been removed and reinstalled | A |
| The door window regulators, power window regulator motor assembly (for driver door) or power window regulator motor assembly (for front passenger door), door glass and door glass runs have not been removed and reinstalled | B |
|
| ||||
| |||||
| 10.INITIALIZE POWER WINDOW CONTROL SYSTEM |
If any of the front door window regulators, power window regulator motor assembly (for driver door) or power window regulator motor assembly (for front passenger door), door glass or door glass runs have been removed and reinstalled, perform "Initialize Power Window Control System" for the applicable door glass (Click here).
| |||||
| 11.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|