DTC C1AB4 Open in Outer Mirror Indicator(Master) |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1AB4 | When either of the following conditions is met:
|
|

| 1.CHECK DTC |
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again.
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH, BODY GROUND - OUTER MIRROR CONTROL ECU ASSEMBLY RH) |
Disconnect the O43 blind spot monitor sensor RH connector.
Disconnect the J10 outer mirror control ECU assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O43-4 (OMIR) - J10-10 (BDSR) | Always | Below 1 Ω |
| J10-7 (GND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.INSPECT OUTER MIRROR CONTROL ECU ASSEMBLY RH |
Disconnect the z17 outer mirror control ECU assembly RH connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J10-10 (BDSR) - z17-7 (BSM+) | Always | Below 1 Ω |
| J10-7 (GND) - z17-12 (BSM-) | Always | Below 1 Ω |
| *a | Component without harness connected (Outer Mirror Control ECU Assembly RH) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR ASSEMBLY RH - OUTER REAR VIEW MIRROR RH (OUTER REAR VIEW MIRROR INDICATOR RH)) |
Disconnect the IND2 outer rear view mirror RH (outer rear view mirror indicator RH) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| z17-7 (BSM+) - IND2-1 (+) | Always | Below 1 Ω |
| z17-12 (BSM-) - IND2-2 (-) | Always | Below 1 Ω |
|
| ||||
| OK | |
| 5.INSPECT OUTER REAR VIEW MIRROR RH (OUTER REAR VIEW MIRROR INDICATOR RH) |
Remove the outer rear view mirror RH (outer rear view mirror indicator RH) (Click here).
Inspect the outer rear view mirror indicator RH on the outer rear view mirror RH (Click here).
|
| ||||
| OK | |
| 6.CHECK DTC |
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again.
|
| ||||
| OK | ||
| ||