DTC C1AB5 Open in Outer Mirror Indicator(Slave) |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1AB5 | When either of the following conditions is met:
|
|

| 1.CHECK DTC |
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again.
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH, BODY GROUND - OUTER MIRROR CONTROL ECU ASSEMBLY LH) |
Disconnect the T17 blind spot monitor sensor LH connector.
Disconnect the K12 outer mirror control ECU assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T17-4 (OMIL) - K12-10 (BDSL) | Always | Below 1 Ω |
| K12-7 (GND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.INSPECT OUTER MIRROR CONTROL ECU ASSEMBLY LH |
Disconnect the z18 outer mirror control ECU assembly LH connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K12-10 (BDSL) - z18-7 (BSM+) | Always | Below 1 Ω |
| K12-7 (GND) - z18-12 (BSM-) | Always | Below 1 Ω |
| *a | Component without harness connected (Outer Mirror Control ECU Assembly LH) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR ASSEMBLY LH - OUTER REAR VIEW MIRROR LH (OUTER REAR VIEW MIRROR INDICATOR LH)) |
Disconnect the IND1 outer rear view mirror LH (outer rear view mirror indicator LH) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| z18-7 (BSM+) - IND1-1 (+) | Always | Below 1 Ω |
| z18-12 (BSM-) - IND1-2 (-) | Always | Below 1 Ω |
|
| ||||
| OK | |
| 5.INSPECT OUTER REAR VIEW MIRROR LH (OUTER REAR VIEW MIRROR INDICATOR LH) |
Remove the outer rear view mirror LH (outer rear view mirror indicator LH) (Click here).
Inspect the outer rear view mirror indicator LH on the outer rear view mirror LH (Click here).
|
| ||||
| OK | |
| 6.CHECK DTC |
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again.
|
| ||||
| OK | ||
| ||