DTC P011515 Engine Coolant Temperature Sensor 1 Circuit Short to Battery or Open |
| DTC No. | DTC Detection Condition | Trouble Area |
| P011515 | The engine coolant temperature sensor output voltage is higher than 4.91 V for 0.5 seconds or more (1 trip detection logic). |
|
| DTC No. | Coolant Temperature | Malfunction |
| P011515 | -40°C (-40°F) |
|
| Frequency of Operation | Continuous |
| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ VALUE USING GTS (CHECK FOR OPEN IN WIRE HARNESS) |
Disconnect the engine coolant temperature sensor connector.

| *1 | Engine Coolant Temperature Sensor | *2 | ECM |
| *a | Front view of wire harness connector (to Engine Coolant Temperature Sensor) | - | - |
Connect terminals 2 (THW) and 1 (E2) of the engine coolant temperature sensor connector on the wire harness side.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List / All Data / Coolant Temperature.
Read the value displayed on the GTS.
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (ENGINE COOLANT TEMPERATURE SENSOR - ECM) |
Disconnect the engine coolant temperature sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E97-2 (THW) - E96-104 (THW) | Always | Below 1 Ω |
| E97-1 (E2) - E96-105 (ETHW) | Always | Below 1 Ω |
| E97-2 (THW) or E96-104 (THW) - Other terminals | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||