DTC P032515 Knock Sensor 1 Bank 1 or Single Sensor Circuit Short to Battery or Open |
| DTC No. | DTC Detection Condition | Trouble Area |
| P032515 | The knock control sensor output voltage is higher than 4.5 V for 1 second or more (1 trip detection logic). |
|
| Frequency of Operation | Continuous |
| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK TERMINAL VOLTAGE (POWER SOURCE OF KNOCK CONTROL SENSOR) |
![]() |
Disconnect the knock control sensor connector.
| *a | Front view of wire harness connector (to Knock Control Sensor) |
Turn the engine switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G1-2 - G1-1 | Engine switch on (IG) | 4.5 to 5.5 V |
|
| ||||
| OK | |
| 2.INSPECT KNOCK CONTROL SENSOR |
Inspect the knock control sensor (Click here).
|
| ||||
|
| ||||
| 3.CHECK HARNESS AND CONNECTOR (KNOCK CONTROL SENSOR - ECM) |
Disconnect the knock control sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G1-2 - E96-124 (KNK1) | Always | Below 1 Ω |
| G1-1 - E96-123 (EKNK) | Always | Below 1 Ω |
| G1-2 or E96-124 (KNK1) - Other terminal | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK WHETHER DTC OUTPUT RECURS (DTC P032515) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Clear the DTCs.
Turn the engine switch off and wait for at least 30 seconds.
Turn the engine switch on (IG).
Turn the GTS on.
Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTCs are not output | A |
| DTC P032515 is output | B |
|
| ||||
| A | ||
| ||