DTC P210014 Throttle Actuator "A" Control Motor Circuit Short to Ground or Open |
DTC P210015 Throttle Actuator "A" Control Motor Circuit Short to Battery or Open |
| DTC No. | DTC Detection Condition | Trouble Area |
| P210014 | Both of the following conditions are met for 2 seconds (1 trip detection logic): (a) The throttle actuator drive duty cycle is 80% or higher. (b) The throttle actuator current is less than 0.5 A. |
|
| P210015 | Either of the following conditions is met (1 trip detection logic):
|
|
| Required Sensors/Components | Throttle actuator (throttle body with motor assembly) |
| Frequency of Operation | Continuous |

| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY (RESISTANCE OF THROTTLE ACTUATOR) |
Inspect the throttle body with motor assembly (Click here).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (THROTTLE BODY WITH MOTOR ASSEMBLY - ECM) |
Disconnect the throttle body with motor assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E16-2 (M+) - E96-16 (M+) | Always | Below 1 Ω |
| E16-1 (M-) - E96-46 (M-) | Always | Below 1 Ω |
| E16-2 (M+) or E96-16 (M+) - Body ground and other terminals | Always | 10 kΩ or higher |
| E16-1 (M-) or E96-46 (M-) - Body ground and other terminals | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY (VISUALLY CHECK THROTTLE VALVE) |
Check for foreign matter between the throttle valve and the housing.
|
| ||||
| OK | |
| 4.INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY (THROTTLE VALVE) |
Check if the throttle valve opens and closes smoothly.
|
| ||||
| OK | ||
| ||