DTC P011511 Engine Coolant Temperature Sensor 1 Circuit Short to Ground |
| DTC No. | DTC Detection Condition | Trouble Area |
| P011511 | The engine coolant temperature sensor output voltage is less than 0.142 V for 0.5 seconds or more (1 trip detection logic). |
|
| DTC No. | Coolant Temperature | Malfunction |
| P011511 | 140°C (284°F) | Short to ground in THW circuit |
| Frequency of Operation | Continuous |
| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.READ VALUE USING GTS (CHECK FOR SHORT IN WIRE HARNESS) |
![]() |
Disconnect the engine coolant temperature sensor connector.
| *1 | Engine Coolant Temperature Sensor |
| *2 | ECM |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List / All Data / Coolant Temperature.
Read the value displayed on the GTS.
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (ENGINE COOLANT TEMPERATURE SENSOR - ECM) |
Disconnect the engine coolant temperature sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E97-2 (THW) or E96-104 (THW) - Body ground and other terminals | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||