Home › Drivetrain › U760E (AUTOMATIC TRANSMISSION / TRANSAXLE) › TRANSMISSION CONTROL CABLE › 2017.09–2018.04
RM33A0E _52 Drivetrain _065350 U760E AUTOMATIC TRANSMISSION / TRANSAXLE _0326603 TRANSMISSION CONTROL CABLE A

U760E AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION CONTROL CABLE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission control cable assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: w/ Smart Entry and Start System

*2: w/o Smart Entry and Start System

Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Replacement of ECM Perform Vehicle Identification Number (VIN) or frame number registration MIL comes on (Click here)
Perform code registration (Immobiliser system) Engine start function See Service Bulletin for the registration method.
ECM (If possible, read the transaxle compensation code from the previous ECM) Possible Perform the following procedures in the order shown:
1.

Reset Memory

2.

Transfer transaxle compensation code

3.

Perform road test to allow ECM to learn


·

Large shift shock

·

The deterioration of fuel efficiency


(Click here)for U760E Initialization
(Click here)for U760E Registration
Impossible Perform the following procedures in the order shown:
1.

Reset Memory

2.

Reset transaxle compensation code

3.

Perform road test to allow ECM to learn


Replacement of ECM*1 Perform code registration (Immobiliser function)
·

Wireless door lock control system

·

Smart Entry and Start System (for Entry Function)

·

Smart Entry and Start System (for Start Function)

·

Steering lock function


See Service Bulletin for the registration method.
Replacement of ECM*2 Perform code registration (Immobiliser system)
·

Wireless door lock control system

·

Engine start


See Service Bulletin for the registration method.

PROCEDURE

Hide 28800 1.REMOVE BATTERY

Hide 74404A 3.REMOVE BATTERY CLAMP SUB-ASSEMBLY

Hide 17410 4.REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

Hide 58152A 5.REMOVE FRONT LOWER NO. 1 FLOOR HEAT INSULATOR

a.
C370855

Remove the 2 nuts and front lower No. 1 floor heat insulator from the vehicle body.


Hide 6.REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY

Hide 58861B 7.REMOVE NO. 1 CONSOLE BOX DUCT

a.
C370854

Remove the No. 1 console box duct.


Hide 33820B 8.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

a.
C378121

Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.


b.
C378137

Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.


c.
C370856

Remove the 2 nuts and disconnect the transmission control cable assembly from the vehicle body.


d.
C370857

Remove the 2 nuts and then remove the transmission control cable assembly from the vehicle body.