Home › Engine / Hybrid System › 2AR-FE (FUEL) › FUEL PRESSURE PULSATION DAMPER › 2017.09–2021.02
RM33A0E _51 Engine / Hybrid System _065325 2AR-FE FUEL _0328390 FUEL PRESSURE PULSATION DAMPER A

2AR-FE FUEL  FUEL PRESSURE PULSATION DAMPER  INSTALLATION  


PROCEDURE

Hide 23270 1.INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY

a.

Apply a light coat of gasoline or spindle oil to a new O-ring.


b.

Install the O-ring to the fuel pressure pulsation damper assembly.


c.

Install the fuel pressure pulsation damper assembly to the fuel delivery pipe with the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

Make sure that the O-ring is not cracked or jammed when installing the fuel pressure pulsation damper assembly.



Hide 23901 2.CONNECT FUEL TUBE SUB-ASSEMBLY

a.

Connect the fuel tube sub-assembly to the fuel delivery pipe.

Click hereEngine / Hybrid System>2AR-FE (FUEL)>FUEL SYSTEM>PRECAUTION


b.

Engage the 2 claws to install a new No. 2 fuel pipe clamp.


c.

Engage the clamp to connect the fuel tube sub-assembly to the fuel hose clamp.


Hide 17705 3.INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 12601B 4.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION