Home › Vehicle Interior › SEAT › SEAT HEATER SYSTEM
RM33A0E _58 Vehicle Interior _065385 SEAT _0328609 SEAT HEATER SYSTEM J

SEAT  SEAT HEATER SYSTEM  Seat Heater for Front Right Seat does not Operate  


DESCRIPTION

When the seat heater switch of the refreshing seat switch is operated, the air conditioning amplifier assembly receives a signal and operates the front seat heater.

WIRING DIAGRAM

B480024E05
0.896,0.74 1.813,0.938 0.917,0.198 10 false LIN1 0.813,4.344 1.729,4.542 0.917,0.198 10 false SHP+ 0.188,5.417 1.76,5.927 1.573,0.51 10 false Air Conditioning Amplifier Assembly 2.219,4.76 3.135,4.958 0.917,0.198 10 false a18 2.229,4.927 3.802,5.344 1.573,0.417 10 false Seat Heater Control Sub-assembly RH 3.813,5.49 5.479,6.156 1.667,0.667 10 false Front Seat Cushion Heater Assembly RH 3.813,5.333 4.729,5.531 0.917,0.198 10 false a16 5.844,4.344 6.76,4.542 0.917,0.198 10 false A 5.677,5.385 7.104,5.99 1.427,0.604 10 false Front Seatback Heater Assembly RH 2.219,4.24 3.135,4.438 0.917,0.198 10 false 5 2.229,3.208 3.146,3.406 0.917,0.198 10 false 1 2.406,3.313 3.323,3.51 0.917,0.198 10 false +B1 3.375,3.323 4.292,3.521 0.917,0.198 10 false E 3.594,3.208 4.51,3.406 0.917,0.198 10 false 10 3.594,4.24 4.51,4.438 0.917,0.198 10 false 7 3.135,4.354 4.052,4.552 0.917,0.198 10 false HTR1 2.406,4.365 3.323,4.563 0.917,0.198 10 false SWR 1.344,4.135 2.26,4.333 0.917,0.198 10 false 16 1.313,4.344 2.229,4.542 0.917,0.198 10 false K56 4.115,2.458 5.031,2.656 0.917,0.198 10 false 2 4.115,3.208 5.031,3.406 0.917,0.198 10 false 6 4.125,4.24 5.042,4.438 0.917,0.198 10 false 1 5.51,1.802 7.073,2.292 1.563,0.49 10 false from S/HTR F/R Relay 2.531,1.396 4.708,1.698 2.177,0.302 10 false Refreshing Seat Switch 2.542,1.25 3.458,1.448 0.917,0.198 10 false K49 2.656,0.76 3.573,0.958 0.917,0.198 10 false SLIN 2.469,0.583 3.385,0.781 0.917,0.198 10 false 3 1.344,0.521 2.26,0.719 0.917,0.198 10 false 14 1.302,0.74 2.219,0.938 0.917,0.198 10 false K54 4.292,1.948 5.531,2.292 1.24,0.344 10 false S/HTR F/R 5.844,2.573 6.76,2.771 0.917,0.198 10 false A 5.844,4.146 6,4.344 0.156,0.198 10 false 1 5.854,2.375 6.01,2.573 0.156,0.198 10 false 2 0.896,6.344 2.542,6.635 1.646,0.292 10 false : LIN Communication Line

CAUTION / NOTICE / HINT

NOTICE:
·

If the battery voltage is low, the seat heater system may not operate due to operation of battery load control, check the Data List item "Battery Control Count (Body ECU)".

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DATA LIST / ACTIVE TEST

·

Inspect the fuses for circuits related to this system before performing the following procedure.



PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Air Conditioner > Clear DTCs
50002 121

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Air Conditioner > Trouble Codes
50001 121
OK:

DTC B14B5 or B14C0 is not output.



Result:
Proceed to
OK
NG



OK

3.PERFORM ACTIVE TEST USING GTS

NG

GO TO DIAGNOSTIC TROUBLE CODE CHART

3.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Front Right Seat Heater Front seat RH side seat heater operation OFF or ON -
Body Electrical > Air Conditioner > Active Test
Tester Display
Front Right Seat Heater
50004 121 116
OK:

The seat heater operates normally.



Result:
Proceed to
OK
NG



OK

NG

4.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY RH
4.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY RH
a.

Remove the front seat cushion heater assembly RH.

for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER(for Manual Seat)>REMOVAL

for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER(for Power Seat)>REMOVAL


b.

Inspect the front seat cushion heater assembly RH.

for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER(for Manual Seat)>INSPECTION

for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER(for Power Seat)>INSPECTION


Result:
Proceed to
OK
NG



OK

5.INSPECT FRONT SEATBACK HEATER ASSEMBLY RH

NG

REPLACE FRONT SEAT CUSHION HEATER ASSEMBLY RH

5.INSPECT FRONT SEATBACK HEATER ASSEMBLY RH
a.

Remove the front seatback heater assembly RH.

for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEATBACK HEATER(for Manual Seat)>REMOVAL

for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEATBACK HEATER(for Power Seat)>REMOVAL


b.

Inspect the front seatback heater assembly RH.

for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEATBACK HEATER(for Manual Seat)>INSPECTION

for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEATBACK HEATER(for Power Seat)>INSPECTION


Result:
Proceed to
OK
NG



OK

6.CHECK HARNESS AND CONNECTOR (IG POWER SUPPLY - SEAT HEATER CONTROL SUB-ASSEMBLY RH)

NG

REPLACE FRONT SEATBACK HEATER ASSEMBLY RH

6.CHECK HARNESS AND CONNECTOR (IG POWER SUPPLY - SEAT HEATER CONTROL SUB-ASSEMBLY RH)
a.
B480034C05
1.563,0.24 2,0.521 0.438,0.281 0.865,1.313 1.271,1.313 true 0.406,0.302 0.708,0.531 0.302,0.229 10 false *a 1.667,0.302 1.969,0.531 0.302,0.229 10 false a18 0.604,1.26 0.906,1.49 0.302,0.229 10 false +B1
*a Front view of wire harness connector
(to Seat Heater Control Sub-assembly RH)


Disconnect the a18 seat heater control sub-assembly RH connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
a18-1 (+B1) - Body ground Engine switch on (IG) 11 to 14 V
a18-1 (+B1) - Body ground Engine switch off Below 1 V



Result:
Proceed to
OK
NG



OK

7.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - SEAT HEATER CONTROL SUB-ASSEMBLY RH)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

7.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - SEAT HEATER CONTROL SUB-ASSEMBLY RH)
a.

Disconnect the a18 seat heater control sub-assembly RH connector.


b.

Disconnect the K56 air conditioning amplifier assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K56-16 (SHP+) - a18-5 (SWR) Always Below 1 Ω
K56-16 (SHP+) or a18-5 (SWR) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

8.CHECK HARNESS AND CONNECTOR (SEAT HEATER CONTROL SUB-ASSEMBLY RH - FRONT SEAT CUSHION HEATER ASSEMBLY RH)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

8.CHECK HARNESS AND CONNECTOR (SEAT HEATER CONTROL SUB-ASSEMBLY RH - FRONT SEAT CUSHION HEATER ASSEMBLY RH)
a.

Disconnect the a16 front seat cushion heater assembly RH connector.


b.

Disconnect the a18 seat heater control sub-assembly RH connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
a18-10 (E) - a16-6 Always Below 1 Ω
a18-10 (E) or a16-6 - Body ground Always 10 kΩ or higher
a18-7 (HTR1) - a16-1 Always Below 1 Ω
a18-7 (HTR1) or a16-1 - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

9.CHECK HARNESS AND CONNECTOR (FRONT SEAT CUSHION HEATER ASSEMBLY RH - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

9.CHECK HARNESS AND CONNECTOR (FRONT SEAT CUSHION HEATER ASSEMBLY RH - BODY GROUND)
a.

Disconnect the a16 front seat cushion heater assembly RH connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
a16-2 - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

10.REPLACE SEAT HEATER CONTROL SUB-ASSEMBLY RH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

10.REPLACE SEAT HEATER CONTROL SUB-ASSEMBLY RH
a.

Temporarily replace the seat heater control sub-assembly RH with a new or known good one.

Click hereVehicle Interior>SEAT>SEAT HEATER CONTROL>REMOVAL


Result:
Proceed to
NEXT



NEXT

11.CHECK SEAT HEATER OPERATION
11.CHECK SEAT HEATER OPERATION
a.

Check the operation of the front seat heater.

Click hereVehicle Interior>SEAT>SEAT HEATER SYSTEM>OPERATION CHECK

OK:

The seat heater operates normally.



Result:
Proceed to
OK
NG



OK

END (SEAT HEATER CONTROL SUB-ASSEMBLY RH WAS DEFECTIVE)

NG

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY