Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › 2017.09–2021.02
RM33A0E _58 Vehicle Interior _065384 PRE-COLLISION _0319645 PRE-COLLISION SYSTEM T

PRE-COLLISION  PRE-COLLISION SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.

·

The pre-collision system uses the CAN communication system. First, confirm that there are no malfunctions in the CAN communication system. Refer to How to Proceed with Troubleshooting.



Pre-collision System
Symptom Suspected Area Link
"Pre-Collision System Unavailable" is displayed Perform millimeter wave radar sensor assembly adjustment*1 Click here
Millimeter wave radar sensor assembly temperature malfunction Click here
Millimeter wave radar sensor assembly low voltage malfunction Click here
Millimeter wave radar sensor assembly Click here
Combination meter assembly Click here
"Pre-Collision System Unavailable Clean Sensor" is displayed Foreign matter attached to millimeter wave radar sensor assembly -
Millimeter wave radar sensor assembly Click here
Combination meter assembly Click here
"Front Camera Unavailable" is displayed Check current condition of forward recognition camera based on related Data List items.
·

Abnormal forward recognition camera voltage

·

Forward recognition camera temperature outside of operational range


Click here
Forward recognition camera Click here
Combination meter assembly Click here
Millimeter wave radar sensor assembly Click here
"Front Camera Vision Blocked Clean and Demist Windshield" is displayed Foreign matter attached to forward recognition camera or area of windshield glass in front of forward recognition camera -
Forward recognition camera Click here
Combination meter assembly Click here
Millimeter wave radar sensor assembly Click here
Although there is possibility of collision, pre-collision controls (all controls) do not operate ("Pre-collision System Unavailable" is not displayed) Check if pre-collision system is canceled -
Vehicle condition/environment does not match the pre-collision system operation conditions (Confirm control operation conditions) Click here
Check installation condition of millimeter wave radar sensor assembly Click here
Perform millimeter wave radar sensor assembly adjustment Click here
Millimeter wave radar sensor assembly Click here
Check installation condition of forward recognition camera Click here
Perform forward recognition camera adjustment Click here
Forward recognition camera Click here
Although there is no possibility of collision, pre-collision controls (all controls) operate Vehicle condition/environment does not match the pre-collision system operation conditions (Confirm control operation conditions) Click here
Check installation condition of millimeter wave radar sensor assembly Click here
Perform millimeter wave radar sensor assembly adjustment Click here
Millimeter wave radar sensor assembly Click here
Check installation condition of forward recognition camera Click here
Perform forward recognition camera adjustment Click here
Forward recognition camera Click here
Pre-collision system does not operate Check if pre-collision system is canceled -
ECU power source circuit Click here
Millimeter wave radar sensor assembly Click here
Pre-collision system cannot be canceled (PCS warning light does not illuminate) Check steering pad switch assembly condition -
Combination meter assembly (check if indicator illuminates using Active Test) Click here
Millimeter wave radar sensor assembly Click here
Combination meter assembly Click here
Pre-collision system warning timing cannot be changed (warning timing setting screen not displayed on multi-information display) Millimeter wave radar sensor assembly Click here
Combination meter assembly Click here

*1: If error code 7 is output during beam axis alignment, clear the DTCs and perform beam axis alignment again.