12631A
1.INSTALL ENGINE COVER BRACKET
Install the engine cover bracket to the cylinder head cover sub-assembly LH with the bolt.
16522
2.INSTALL WATER FILLER BRACKET
| *a | Stopper |
| *b | Protrusion |
Temporarily install the water filler bracket to the camshaft housing sub-assembly LH with the 2 bolts.
Fully tighten the 2 bolts in the order shown in the illustration.
Make sure that the stopper of the water filler bracket is pressed against the protrusion of the camshaft housing sub-assembly LH when fully tightening the 2 bolts.
3.INSTALL WIRE HARNESS CLAMP BRACKET
Install the wire harness clamp bracket to the camshaft housing sub-assembly with the bolt.
Install the wire harness clamp bracket to the camshaft housing sub-assembly LH with the bolt.
43457
4.INSTALL DRIVE SHAFT BEARING BRACKET
Install the drive shaft bearing bracket to the cylinder block sub-assembly with the 3 bolts.
Make sure that there is no oil on the threads of the bolts.
12585
5.INSTALL NO. 5 CYLINDER BLOCK INSULATOR (w/ Oil Cooler)
| *a | Fastener Surface |
Install the No. 5 cylinder block insulator to the engine assembly.
Make sure that the No. 5 cylinder block insulator is not covering any fastener surface.
11452
6.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE
Install a new engine oil level dipstick guide O-ring to the engine oil level dipstick guide.
Apply a light coat of engine oil to the engine oil level dipstick guide O-ring.
Insert the engine oil level dipstick guide end into the oil pan sub-assembly.
Install the engine oil level dipstick guide to the camshaft housing sub-assembly LH with the bolt.
Install the engine oil level dipstick to the engine oil level dipstick guide.
16173
7.INSTALL WATER PUMP PULLEY
16620
8.INSTALL V-RIBBED BELT TENSIONER ASSEMBLY
Install the V-ribbed belt tensioner assembly with the 2 bolts.
16604
9.INSTALL NO. 2 IDLER PULLEY SUB-ASSEMBLY
88431
10.INSTALL NO. 1 COMPRESSOR MOUNTING BRACKET
Temporarily install the No. 1 compressor mounting bracket to the cylinder block sub-assembly with the 2 bolts.
Fully tighten the 2 bolts in the order shown in the illustration.
11.INSTALL COMPRESSOR ASSEMBLY WITH MAGNETIC CLUTCH
27020
12.INSTALL GENERATOR ASSEMBLY
16361A
13.INSTALL V-RIBBED BELT
12262
14.INSTALL NO. 2 VENTILATION HOSE
Install the No. 2 ventilation hose to the cylinder head cover sub-assembly and slide the clip to secure it.
12261
15.INSTALL VENTILATION HOSE
Install the ventilation hose to the PCV valve (ventilation valve sub-assembly) and slide the clip to secure it.
16264
16.INSTALL NO. 2 WATER BY-PASS HOSE
Install the No. 2 water by-pass hose to the water outlet and slide the clip to secure it.
16267
17.INSTALL NO. 3 WATER BY-PASS HOSE
Install the No. 3 water by-pass hose to the water inlet pipe and slide the clip to secure it.
29300
18.INSTALL VACUUM PUMP ASSEMBLY
19500
19.INSTALL IGNITION COIL ASSEMBLY
82219A
20.INSTALL SENSOR WIRE
Engage the 2 clamps and install the sensor wire with the bolt.
89615
21.INSTALL KNOCK CONTROL SENSOR