Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2017.12–2018.04
RM33A0E _58 Vehicle Interior _065381 METER / GAUGE / DISPLAY _0323396 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Tachometer Malfunction  


DESCRIPTION

In this circuit, the combination meter assembly receives engine speed signals from the ECM via CAN communication. The combination meter assembly displays the engine speed calculated based on the data received from the ECM.

WIRING DIAGRAM

E143765E83
0.583,3.115 1.24,3.448 0.656,0.333 10 ECM 2.927,3.167 3.49,3.583 0.563,0.417 10 : 3,3.188 4.719,3.563 1.719,0.375 10 CAN Communication Line 5.24,3.115 7.156,3.375 1.917,0.26 10 Combination Meter Assembly

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

·

Before replacing the ECM, refer to Service Bulletin.



PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check if CAN communication DTCs are output.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM


Result:
Result Proceed to
CAN communication DTCs are not output A
CAN communication DTCs are output B



A

2.CHECK FOR DTC (SFI SYSTEM)

B

2.CHECK FOR DTC (SFI SYSTEM)
a.

Check if SFI system DTCs are output.

Powertrain > Engine > Trouble Codes
50001 372

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

3.PERFORM ACTIVE TEST USING GTS

B

3.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
TachoMeter Operation (0rpm) Tachometer (0 rpm) ON -
TachoMeter Operation (1000rpm) Tachometer (1000 rpm) ON -
TachoMeter Operation (2000rpm) Tachometer (2000 rpm) ON -
TachoMeter Operation (3000rpm) Tachometer (3000 rpm) ON -
TachoMeter Operation (4000rpm) Tachometer (4000 rpm) ON -
TachoMeter Operation (5000rpm) Tachometer (5000 rpm) ON -
TachoMeter Operation (6000rpm) Tachometer (6000 rpm) ON -
TachoMeter Operation (7000rpm) Tachometer (7000 rpm) ON -
Body Electrical > Combination Meter > Active Test
Tester Display
TachoMeter Operation (1000rpm)
50004 409 211
Body Electrical > Combination Meter > Active Test
Tester Display
TachoMeter Operation (2000rpm)
50004 409 212
Body Electrical > Combination Meter > Active Test
Tester Display
TachoMeter Operation (3000rpm)
50004 409 213
Body Electrical > Combination Meter > Active Test
Tester Display
TachoMeter Operation (4000rpm)
50004 409 214
Body Electrical > Combination Meter > Active Test
Tester Display
TachoMeter Operation (5000rpm)
50004 409 215
Body Electrical > Combination Meter > Active Test
Tester Display
TachoMeter Operation (6000rpm)
50004 409 216
Body Electrical > Combination Meter > Active Test
Tester Display
TachoMeter Operation (7000rpm)
50004 409 217
OK:

Tachometer indication is normal.



Result:
Proceed to
OK
NG



OK

NG

REPLACE COMBINATION METER ASSEMBLY