Home › Engine / Hybrid System › 6AR-FSE (ENGINE CONTROL) › CAMSHAFT OIL CONTROL VALVE (for Intake Side) › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072203 6AR-FSE ENGINE CONTROL _0351509 CAMSHAFT OIL CONTROL VALVE(for Intake Side) A

6AR-FSE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE(for Intake Side)  INSTALLATION  


PROCEDURE

Hide 13523F 2.INSTALL CAMSHAFT TIMING GEAR BOLT

a.
A337898

Apply engine oil to the areas of the camshaft timing gear bolt shown in the illustration.


b.

Temporarily install the camshaft timing gear bolt to the camshaft timing gear assembly.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

If the camshaft timing gear bolt has been struck or dropped, replace it.


HINT:

Make sure that the flange part of the camshaft timing gear bolt contacts the entire circumference of the camshaft timing gear assembly.



c.

Loosen the camshaft timing gear bolt 60 to 180°.


d.

Turn the crankshaft pulley clockwise 60 to 120°.


e.

While holding the crankshaft pulley set bolt, tighten the camshaft timing gear bolt.

Torque:
95 N*m (969 kgf*cm, 70 ft.*lbf)


f.

Engage the clamp to connect the engine wire.


Hide 15370 3.INSTALL CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY

Hide 12601B 4.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 53736 5.INSTALL FRONT FENDER APRON SEAL RH

Hide 6.INSPECT FOR ENGINE OIL LEAK