Home › Engine / Hybrid System › 6AR-FSE (ENGINE CONTROL) › CAMSHAFT POSITION SENSOR › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072203 6AR-FSE ENGINE CONTROL _0351516 CAMSHAFT POSITION SENSOR A

6AR-FSE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11102A 1.INSTALL CAMSHAFT POSITION SENSOR (for Intake Side)

a.

Clean and degrease the threads of the bolt for the camshaft position sensor.


b.

Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

NOTICE:

If reusing the camshaft position sensor, be sure to inspect the O-ring.



c.
A192239C95
1.49,1.938 1.781,1.938 1.781,1.938 1.865,1.583 false 1.323,1.844 1.635,2 0.313,0.156 10 false *a
*a Adhesive 1324


Apply adhesive to 2 or 3 threads of the bolt.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.



d.

Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the camshaft position sensor has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.




e.

Connect the camshaft position sensor connector.


Hide 23881B 3.INSTALL FUEL HOSE BRACKET

a.

Install the fuel hose bracket to the EGR valve bracket with the engine cover joint.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


Hide 17705 4.INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 11102A 5.INSTALL CAMSHAFT POSITION SENSOR (for Exhaust Side)

a.

Clean and degrease the threads of the bolt for the camshaft position sensor.


b.

Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

NOTICE:

If reusing the camshaft position sensor, be sure to inspect the O-ring.



c.
A192239C95
1.49,1.938 1.781,1.938 1.781,1.938 1.865,1.583 false 1.323,1.844 1.635,2 0.313,0.156 10 false *a
*a Adhesive 1324


Apply adhesive to 2 or 3 threads of the bolt.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.



d.

Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the camshaft position sensor has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.




e.

Connect the camshaft position sensor connector.


Hide 6.INSPECT FOR ENGINE OIL LEAK

Hide 12601B 7.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY