Home › Drivetrain › K120 (CVT) › PARK / NEUTRAL POSITION SWITCH › from 2021.02
RM33A0E _52 Drivetrain _098634 K120 CVT _0461787 PARK / NEUTRAL POSITION SWITCH N

K120 CVT  PARK / NEUTRAL POSITION SWITCH  ADJUSTMENT  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during park/neutral position switch assembly adjustment are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: w/ Smart Entry and Start System

*2: w/o Smart Entry and Start System

Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Replacement of ECM Perform Vehicle Identification Number (VIN) or frame number registration MIL comes on (Click here)
Perform code registration (Immobiliser system) Engine start function See Service Bulletin for the registration method
Replacement of ECM*1 Perform code registration (Immobiliser function)
·

Wireless door lock control system

·

Smart Entry and Start System (for Entry Function)

·

Smart Entry and Start System (for Start Function)

·

Steering lock function


See Service Bulletin for the registration method
Replacement of ECM*2 Perform code registration (Immobiliser function)
·

Wireless Door Lock Control System

·

Engine start


See Service Bulletin for the registration method

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal.


PROCEDURE

Hide 1.SECURE VEHICLE

a.

Fully apply the parking brake and chock a wheel.

CAUTION:
C332327

·

Make sure to apply the parking brake and chock a wheel before performing this procedure.

·

If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.




Hide 33820B 2.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

Hide 84540 3.ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.
C413823

Disconnect the park/neutral position switch assembly connector.


b.
C413824

Remove the nut, washer and transmission control shaft lever from the manual valve lever shaft.


c.
C413825

Loosen the 2 bolts of the park/neutral position switch assembly.


d.
C413826C01
2.531,0.51 2.938,0.458 2.938,0.458 2.531,0.677 true 2.969,0.344 3.167,0.563 0.198,0.219 10 false *a
*a Protrusion


Align the protrusions of the park/neutral position switch assembly as shown in the illustration.


e.

Hold the park/neutral position switch assembly in that position and tighten the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


f.

Install the transmission control shaft lever to the manual valve lever shaft with the washer and nut.

Torque:
12.7 N*m (130 kgf*cm, 9 ft.*lbf)

NOTICE:

Be careful of the direction of the transmission control shaft lever.



g.

Connect the park/neutral position switch assembly connector.


Hide 33820B 4.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

Hide 84540 5.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION